Hoftronic Zigbee Puck Dimmer (0.5-250W) User Manual

Quick guide from the manual

This document provides installation and configuration instructions for the Hoftronic Zigbee Puck Dimmer (0.5-250W). It is intended for qualified electricians and covers wiring, pairing with Zigbee hubs, and adjusting dimming parameters.

Installation

Before starting, ensure the AC mains power is disconnected and cannot be unexpectedly reconnected. Install the dimmer according to the provided diagrams:

• Figure 1: Use for 1-gang push button/single pulse switch.
• Figure 2: Use for 2-gang push button/double pulse switch.
• The neutral wire is optional for connection.

Dimmer Adjustment

The dimmer features 4 micro-switches on the front for custom settings:

• Minimum Brightness: Set dimmer to minimum load, then turn the min-adjustment micro-switch to the desired level.
• Boost Function: Eliminates the "popcorn effect" (lights shining brightly before returning to the set level). Adjust using the boost micro-switch.
• Maximum Brightness: Set dimmer to maximum load, then turn the max-adjustment micro-switch to the desired level.
• Dimming Speed: Adjust using the speed micro-switch. Settings: "1" (5s), "2" (8s), "3" (12s).

Pulse Switch Mode

The default is single pulse switch mode. To switch to double pulse mode (connected to S1 and S2):

1. Short press the reset button 4 times.
2. Long press the 5th time until the light flashes once to confirm.

To return to single switch mode, short press the reset button twice, then long press the 3rd time until the light flashes once.

Pairing and Reset

Pairing Mode: Remove the device from any previous Zigbee network. Press the reset button twice. The indicator will flash blue and stay on for 10 seconds upon success. Timeout is 3 minutes.

TouchLink: Reset the dimmer if already in a network. Press the reset button 4 times; the indicator will flash green. Bring the remote within 10 cm of the dimmer and set the remote to TouchLink.

Reset: Press and hold the reset button for 5 seconds. The indicator will remain red for 10 seconds. Note: All configuration parameters will be reset.

Safety and Maintenance

The product is for indoor use only. Maintenance must be performed with power cut off and the product cooled down. Clean only with soft, dry cloths. Do not use chemical detergents. Ensure free air access to prevent overheating.

Technical Support

For more information, visit docs.hoftronic.com/manuals. For the full EU declaration of conformity, visit docs.hoftronic.com/DOC.