Dogtra 1200X Training Collar User Guide

Quick guide from the manual

The Dogtra 1200X is a remote training collar system designed for dog training. Key features include a 1200-meter range (1600m for Black Edition), 100 stimulation levels, Nick/Constant stimulation, vibration, and an audible tone. The system is IPX9K waterproof and expandable to a 3-dog system.

Device Overview

The transmitter features a rheostat dial for intensity control, a stimulation level lock, and an LCD screen displaying the stimulation level and battery life. The receiver is waterproof and features removable contact points.

Getting Started

To turn the transmitter on/off, press and hold the power button on the bottom right for 2 seconds. To turn the receiver on/off, press and hold the power button located between the contact points for 2 seconds. The LED indicator will turn solid green when powered on and red when powered off.

Pairing Additional Receivers

1. Turn on the transmitter and set the stimulation level to 0. Use the toggle to select the desired dog (1, 2, or 3).
2. Ensure the receiver is off. Press and hold the power button for 5 seconds until the LED blinks.
3. Simultaneously press the front transmitter button and the side Boost button until the screen displays 'CD****'.
4. Confirm pairing by pressing the Pager button; the receiver should vibrate.

Stimulation and Training

The 1200X uses a rheostat dial to adjust intensity from 1 to 100. Always start at the lowest level and increase gradually until the dog shows a mild response. The 'Nick' mode provides a single pulse, while 'Constant' provides continuous stimulation for up to 12 seconds. The 'Boost' button allows for an instant increase in stimulation level.

Maintenance and Charging

Charge the batteries for 2 hours before the first use. Use only Dogtra-approved chargers. Ensure the rubber charging port plug is securely in place during use to maintain the waterproof seal. Clean the receiver after use, especially if exposed to saltwater.

Troubleshooting

• No reaction: Ensure the receiver is on and the collar is tight enough for contact points to touch the skin. Increase the intensity level.
• No stimulation: Check battery levels. If the test light works but you feel nothing, your skin tolerance may be higher than the dog's.
• Range issues: Ensure fingers are not covering the antenna. Operate away from electrical conductors like metal structures or radio towers.