Fieldmann FDV 10250-A Cordless Drill User Manual

Quick guide from the manual

The Fieldmann FDV 10250-A is a 12V cordless drill designed for household use. Before first use, ensure the battery is fully charged. Always remove the battery before changing tools or performing adjustments. The tool features a keyless chuck, torque control, and LED work light.

Machine description

The drill consists of the following main components:

• A: Keyless chuck
• B: Torque setting ring
• C: Rotation direction switch
• D: Trigger switch
• E: Handle
• F: Battery charge level LED display
• G: Battery
• H: 2 speed switch
• I: Lighting of the working area

Putting into operation

Charging the machine:

1. Remove the battery from the machine by pressing the release button and pulling down.
2. Place the charger on a table near a power socket.
3. Insert the battery into the charger.
4. Connect the charger to a power socket. Both red and green lights will turn on.
5. Once fully charged, the green light stays on and the red light turns off.
6. Disconnect the charger from the power socket.

Note: For the first charge, it is recommended to charge the battery for 3-5 hours.

Operation

Drill chuck: To open, hold the rear part of the chuck and turn the front part anticlockwise. Insert the tool and tighten by turning the front part clockwise while holding the rear part.

Torque control: Use the setting ring to select from 15 positions + 1 drilling position. Start with the lowest setting and increase as needed.

Turning on/off: Use the trigger switch (no. 1). Pressure on the switch determines the rotation speed. Use the direction switch (no. 2) to select forward or backward rotation. Set to the middle (neutral) position when not in use to prevent accidental starting.

Instructions for proper use

Screwing: Drill a pilot hole in wood first to prevent damage. Use slow speeds and start with low torque.

Drilling: Do not use torque control when drilling. Use wood bits for wood and metal bits for metal/plastic. Use maximum speed for soft wood and lower speed for hard wood.

Maintenance and storage

The tool requires no special maintenance. Regularly check for wear and damage. Clean plastic parts with a soft cloth dipped in lukewarm water; do not use aggressive solvents. Do not submerge in water. Store in a dry location away from heat sources.

Troubleshooting

If the product does not start, check the power supply and connections. If it does not reach full power, check the extension cord and voltage. If results are unsatisfactory, replace dull drill bits. If there is excessive vibration, replace the drill bit or tighten screws.

Technical specifications

• Nominal voltage: 12V
• Idling speed: 0-350 / 0-1400 rpm
• Battery: 1.5 Ah, Li-ion
• Torque: 20 positions + 1 (drilling position)
• Max. diameter: 10 mm