Electronics / Audio
Owner's Manual for Flamma FC19 Distortion Pedal
Quick guide for the Flamma FC19 Distortion Pedal, covering setup, control layout, effect modes, and technical specifications.
Table of contents
Quick guide from the manual
The Flamma FC19 is a compact distortion pedal designed to provide warm, smooth, vintage tones. It features a true bypass circuit and two distinct effect modes. Ensure you use a 9V DC center-negative power supply to operate the device.
Device Layout
The pedal features the following controls and connections:
- Footswitch: Turns the pedal on or off.
- LED Indicator: Shows the current on/off status.
- DC IN: Connection for the 9V DC power supply.
- INPUT: 1/4 inch mono audio jack.
- OUTPUT: 1/4 inch mono audio jack.
- Mode Toggle: Switches between Vintage and Turbo effect modes.
- LEVEL: Adjusts the volume level of the distortion.
- FILTER: Adjusts the tone color of the distortion.
- GAIN: Adjusts the gain level of the distortion.
Safety and Precautions
To ensure safe operation, please adhere to the following:
- Use only the original 9V DC center-negative power supply.
- Unplug the adapter during electrical storms or when not in use.
- Do not operate the device near water or heat sources.
- Clean the unit only with a dry cloth.
- Ensure the device is installed according to manufacturer instructions, away from ventilation openings.
Technical Specifications
- Input: 1/4 inch mono jack (1M ohms impedance)
- Output: 1/4 inch mono jack (1k ohms impedance)
- Power Requirements: 9V DC, center negative
- Current Draw: 3mA
- Dimensions: 47mm (D) x 83mm (W) x 52mm (H)
- Weight: 160g
Practical help
Common problems
Pedal does not turn on
Verify that you are using a 9V DC center-negative power supply and that it is properly connected.
No sound output
Check that your 1/4 inch mono cables are securely connected to the INPUT and OUTPUT jacks and that the pedal is switched on (LED indicator should be active).
Before use
- Ensure you have a 9V DC center-negative power adapter.
- Check that your audio cables are 1/4 inch mono jacks.
- Verify the pedal is placed on a stable surface away from heat sources or water.
Specs in practice
- 9V DC (center negative)
- The required power polarity for the pedal; using the wrong polarity may damage the unit.
- Current Draw: 3mA
- The amount of power the pedal consumes, which is very low, making it compatible with most standard pedalboard power supplies.
Model compatibility
- Requires 1/4 inch mono audio cables for both input and output.
Manual page author
Emily Carter
User documentation editor
Prepares concise manual descriptions and highlights the most useful setup, operation, and maintenance information for readers.