Flamma FS05 Multi-Effects Modulation Pedal Owner's Manual

Quick guide for the Flamma FS05 Multi-Effects Modulation Pedal, covering setup, preset management, effect list, and technical specifications.

Table of contents

Quick guide from the manual

The Flamma FS05 is a stereo modulation pedal featuring 11 distinct modulation effects and 7 preset slots. This document provides essential instructions for power connection, preset management, and factory resets.

Safety and Power Supply

Ensure the pedal is powered by a 9V DC adapter (300mA, center negative). Always unplug the adapter during electrical storms or when the device is not in use. Do not operate near water or heat sources.

Operation and Presets

Switching Presets: Press the SAVE/SELECT button to cycle through the 7 available preset patches.
Saving Presets: If a parameter is changed, the LED will blink slowly. Press and hold the SAVE button to store the current settings; the LED will blink rapidly to confirm a successful save.
Factory Reset: Power off the pedal. Press and hold the SAVE button while powering the unit back on. The 7 LED indicators will blink. Release the button and wait for the blinking to stop to complete the reset.

Effect List

The pedal offers 11 modulation types, each with adjustable parameters via CTRL 1 and CTRL 2 knobs:

CHORUS: Mix/Tone
FLANGER: Mix/Feedback
TREMOLO: Duty/Tone
PHASE: Mix/Tone
VIBRATO: Mix/Tone
ROTARY: Mix/Tone
LIQUID: Mix/Tone
AUTO WAH: Mix/Tone
STUTTER: Duty/Tone
RING: Pitch/Tone
LOW BIT: Smooth/Bit Rate

Technical Specifications

Inputs: 2 x 1/4 inch mono audio jacks (4.7M ohms impedance)
Outputs: 2 x 1/4 inch mono audio jacks (100 ohms impedance)
Power: 9V DC, 300mA
Dimensions: 69.82 x 121.5 x 50.65 mm
Weight: 0.298 kg

Practical help

Common problems

LED blinks slowly

This indicates that a parameter has been changed but not yet saved. Press and hold the SAVE button to store the current settings.

Pedal does not power on

Verify that you are using a 9V DC, 300mA, center-negative power supply.

Need to restore original settings

Perform a factory reset by holding the SAVE button while powering on the device until the LEDs stop blinking.

Before use

Ensure the power supply is 9V DC, 300mA, center negative.
Use the INPUT L (MONO) jack if you are using a mono connection.
Check that your audio cables are 1/4 inch mono jacks.
Verify the pedal is not placed near heat sources or water.

Specs in practice

Impedance (Input): 4.7M ohms, optimized for guitar signals.
Current Draw: 300mA; ensure your power supply can provide at least this amount.

Model compatibility

For mono setups, always use the L (MONO) input and output jacks.

Show more Show less

Manual page author

Michael Turner

Technical manual editor

Reviews PDF manuals for structure, safety notes, and practical product details so readers can find the right information quickly.