General / Accessories
Hilti NCT IS 025-A22 Cordless Cable Cutter User Manual
Quick guide for the Hilti NCT IS 025-A22 cordless electro-hydraulic cable cutter. Includes setup, operation, maintenance, and troubleshooting steps.
Table of contents
Manual images
Jump to the sectionQuick guide from the manual
The Hilti NCT IS 025-A22 is a cordless, electro-hydraulic cutting tool designed for cutting copper (Cu), aluminum (Al), and steel (e.g., ACSR) cables. Before use, ensure all live cables in the working area are switched off or that appropriate safety precautions are taken.
Product Overview
The tool features a cutting head, a manual piston return switch, a casing, a servicing/fault indicator (red LED), a battery release button, a battery, slots for the Hilti retaining leash, a white LED for work area illumination, and a control switch.
Operation
Battery Preparation: Charge the battery fully before first use. Insert the battery into the tool until it clicks audibly into place.
Cutting Procedure:
- Rotate the cutting head to the desired working position (can be rotated 350°).
- Place the cable to be cut fully into the cutting head. Do not exceed the maximum cutting capacity.
- Press the control switch and hold it until the tool releases pressure, accompanied by an audible 'pop'.
- The tool will automatically return to its initial position after the cut.
Maintenance
Always remove the battery before performing any care or maintenance. Clean the tool casing with a slightly damp cloth and the air vents with a dry brush. Do not use silicone-based cleaning agents. Regularly check all visible parts for damage and ensure controls function correctly.
Safety
Always wear protective glasses. Do not use the tool in heavy rain or underwater. After approximately 100 consecutive cuts, allow the tool to cool down for about 15 minutes to prevent overheating.
Manufacturer information
Hilti Corporation
Practical help
Common problems
LEDs on battery do not light up
Ensure the battery is fully inserted (double click) or charge the battery.
Red LED lights continuously with warning tone
Technical problem. Contact Hilti Service.
Red LED flashes with warning tone
Battery charge too low for a complete cycle. Replace and charge the battery.
Tool overheated (Red LED lights briefly)
Allow the product to cool down.
Before use
- Ensure the battery is fully charged.
- Check that the battery is correctly inserted and locked.
- Verify that the cutting head is in the desired position.
- Ensure the cable is fully inserted into the cutting head.
- Confirm that the cable does not exceed the maximum cutting capacity.
Specs in practice
- Max. cable diameter
- 24 mm
- Rated voltage
- 21.6 V
- Weight (with B22/8.0 battery)
- 3.7 kg
Images and diagrams
- Page 2: Overview of the tool components (1-9).
- Page 3: Steps for battery insertion, attaching the retaining leash, and the cutting process.
Model compatibility
- Use only Hilti B 22 series Li-ion batteries.
- Use only Hilti-approved battery chargers.
Manual page author
David Miller
Documentation analyst
Organizes user manual content into clear summaries, with attention to model details, product context, and everyday usability.