Installation Guide for Luminii 0-10V Athena LED Driver 96W

Installation and setup guide for the Luminii 0-10V Athena LED Driver 96W. Includes wiring instructions, clearance requirements, and factory reset procedures.

Table of contents

Quick guide from the manual

This document provides installation instructions for the Luminii 0-10V Athena LED Driver (96W). The device is intended for installation by a qualified electrician in accordance with Article 450 of the National Electrical Code. It is suitable for dry locations and is plenum-rated in accordance with UL2043. Ensure the driver is installed in a well-ventilated area free from explosive gases and vapors.

Installation and Mounting

The LED Driver can be mounted either vertically or horizontally. Proper air circulation is critical for operation.

Clearance: Maintain a minimum of 3 inches of clearance around the LED Driver to ensure proper air circulation.
Wireless Node Clearance: Ensure the Lutron Athena Wireless node has at least 1 inch of clearance from any metal, such as conduit.
Preparation: Before installing, verify that the LED Driver has the correct input voltage, output voltage, and wattage for the specific job. Check wire markings against the wiring diagram.

Wiring Instructions

Follow these steps to connect the driver:

Remove the cover from the top of the driver housing to expose the wires. The screws for the cover are located inside the housing.
Connect the 120-277V AC power into the housing from the electrical panel.
Connect the 24V DC low voltage conduit for the LED.
Note: There are no control wire connections to make, as the power supply is already connected to the Athena wireless node.
Insert the wire nut connections into the driver housing.
Close the housing cover and secure it using the eight screws.

Factory Resetting the Lutron Athena Wireless Node

If a node is not working or cannot be added to a new project, perform a factory reset using the Lutron App:

Open the Lutron App and ensure your device is connected to the same WiFi as the Lutron Athena nodes.
Select Professional.
Sign into your myLutron Account.
Click Next to pass through the Account screen.
Select Access an Existing System.
Select More options.
Click Reset Device.
Select Continue using app and follow the on-screen directions.
To confirm the reset, power cycle the load connected to the Athena wireless node. The load will either dim to off or cycle through CCTs and then turn to full brightness.

Technical Specifications

Input: 120-277V AC, 1.1A, 50/60Hz
Output: 24V DC, 4.0A
Max Wattage: 96W

Practical help

Common problems

Node not working or cannot be added to a new project

Perform a factory reset using the Lutron App by navigating to 'More options' > 'Reset Device'.

Overheating or poor performance

Ensure there is at least 3 inches of clearance around the LED Driver for proper air circulation.

Before use

Verify the LED Driver has the proper input voltage, output voltage, and wattage for the job.
Ensure the installation location is dry and well-ventilated.
Confirm the installer is a qualified electrician.
Check that the Lutron Athena Wireless node has at least 1 inch of clearance from metal.
Verify wire markings match the wiring diagram.

Specs in practice

Input Voltage: 120-277V AC, 1.1A, 50/60Hz; ensure your electrical panel matches this range.
Output Voltage: 24V DC, 4.0A; ensure the connected LED load is compatible with this output.

Model compatibility

Suitable for dry locations.
Plenum rated in accordance with UL2043.
Must be installed in accordance with Article 450 of the National Electrical Code.

Show more Show less

Manual page author

Michael Turner

Technical manual editor

Reviews PDF manuals for structure, safety notes, and practical product details so readers can find the right information quickly.