Lighting / Outdoor Lighting
Philips Crust LED Ground Spot User Manual
Quick guide for the Philips Crust LED Ground Spot. Includes installation steps, wiring requirements, load capacity, and safety usage instructions.
Quick answers from the manual
Quick answer
- The Philips Crust is an LED ground spot light. Installation requires specific cable diameters (10-13.5mm) and it is rated IP44. It supports a maximum load of 2000kg (20kN). p. 2, 3
Key actions
- Installation p. 4, 5, 6, 7
First start
- Ensure power is off, prepare cable, install, and seal. p. 4, 9
Maintenance and reset
- Clean with water. p. 9
Technical specifications
| Parameter | Value | Meaning | Pages |
|---|---|---|---|
| Load Capacity | 20kN (2000kg) | Max weight the unit can withstand | p. 3 |
Where to find it in the PDF
- Installation and Safety p. 2, 3, 4, 5
Table of contents
Manual images
Click an image to enlargeImportant Information
The Philips Crust is an LED ground spot light designed for outdoor use. It is rated IP44, meaning it is protected against splashing water. The unit has a maximum load capacity of 20kN (approximately 2000kg). It must be used only in restricted accessible areas, such as pedestrian and bicycle zones.
Installation Requirements
Before beginning installation, ensure you have the following:
- Screwdriver (flat and cross-head)
- Pencil for marking
- Cable with a diameter between 10mm and 13.5mm
- Compatible cable type: 3 x 1.5mm² / 3 x 2.5mm²
Installation Steps
- Preparation: Ensure the power supply is switched off at the circuit breaker.
- Marking: Use the provided template to mark the installation area.
- Drilling: Drill the necessary hole (diameter 105mm).
- Wiring: Feed the cable through the cable gland. Ensure the cable diameter is within the specified range (10-13.5mm) to maintain the IP44 seal.
- Connection: Connect the wires according to the internal terminal block instructions.
- Assembly: Secure the unit into the ground, ensuring all screws are tightened to maintain the seal.
- Finalization: Once installed, switch the power back on.
Safety and Usage
The luminaire must be used in restricted accessible areas only (e.g., pedestrian and bicycle zones). Do not install in areas with heavy vehicle traffic. Ensure the cable gland is tightened correctly to prevent water ingress. Clean the unit with water when necessary.
Manufacturer information
Philips
Practical help
Common problems
Water ingress or electrical failure
Ensure the cable gland is tightened correctly and the cable diameter is within the 10mm-13.5mm range.
Before use
- Ensure power is switched off at the breaker
- Verify cable diameter is between 10mm and 13.5mm
- Check that the installation area is a restricted zone (pedestrian/bicycle only)
- Ensure tools (screwdriver, pencil) are ready
Images and diagrams
- Page 2: Tools and cable specifications
- Page 3: Load capacity and SELV zone requirements
- Page 4-8: Step-by-step installation sequence
Model compatibility
- Restricted to pedestrian and bicycle zones only.
Manual page author
Michael Turner
Technical manual editor
Reviews PDF manuals for structure, safety notes, and practical product details so readers can find the right information quickly.