User Manual for Truper 102492-03-OK Battery Charger

Quick Guide

The Truper 102492-03-OK is a battery charger designed to charge two batteries of different capacities simultaneously. It operates on a 127 V~ power supply.

Operating Instructions

1. Connect the charger to a suitable 127 V~ mains socket. The indicator light will turn green.
2. Insert the battery into the charger until it stops, aligning it with the guide. The indicator light will change from green to red, signaling that charging has started.
3. Once the battery is fully charged, the indicator light will turn green again, and the red light will turn off.
4. Disconnect the charger from the mains socket and remove the battery.

Troubleshooting Battery Failures

• Red light flashes: The battery has a delay caused by heat. Wait until the battery temperature is in the proper range to charge.
• Red light remains on for an extended period: The battery is defective. You must replace it or visit a Truper Authorized Service Center.
• Red and green lights flash alternately: The battery is defective. You must replace it or visit a Truper Authorized Service Center.

Battery Maintenance

• Charge the battery to its maximum capacity before using the machine for the first time.
• Always charge the battery to its maximum capacity.
• Do not leave the battery uncharged for more than three months.
• Discharge the battery completely at least once per month.

Safety Warnings

Warning: Risk of injury and damages. Only charge the specified type of battery, as other batteries may burst. Do not use the charger in damp conditions.