Assembly and User Guide for Anko 1.82M Prelit Christmas Tree

Quick guide from the manual

This manual provides instructions for the assembly, safe operation, and storage of the Anko 1.82M Prelit Christmas Tree. The tree is designed for indoor use only and features non-replaceable LED bulbs. Ensure you read all safety warnings before connecting the tree to a power supply.

Assembly Instructions

1. Place the tree stand on a level surface.
2. Slide the legs upwards into the slots at the base of the trunk until they are firmly secure.
3. Insert section B into the tree stand, then insert the tree top (section A) into the trunk. Ensure the tab fits tightly into the slot in the tree trunk.
4. Open all branches. Start shaping the branches with the tips farthest from the pole, moving one to the right, one to the left, and one to the center of the main stem.
5. After shaping, step back to check the overall look and adjust branches to fill any gaps. Slightly upsweep all branch tips for a natural look.
6. Connect the light set to the provided connector and plug the connector into the adaptor. Finally, plug the adaptor into the power outlet.
7. Connect the male and female plugs by locating the matching color-coding labels.

Disassembly and Storage

• Keep the original carton for storage.
• Disconnect the plug from the wall outlet and remove all ornaments and decorations.
• Disassemble the tree by reversing the assembly sequence. Do not detach factory pre-plugged light sets.
• If you have difficulty separating the tree poles, apply a small amount of lubricant at the joint and rotate the upper pole in both directions before lifting.
• Press branches against the stem before removing the top-to-bottom sections.
• Store the tree in its box in a cool, dry place. Do not store in areas where the temperature exceeds 40°C (90°F) or in direct sunlight.

Safety and Installation

Important Safety Warnings:

• This product is for INDOOR USE ONLY.
• The adaptor must be installed indoors, away from weather.
• Do not position the tree near heaters or other direct heat sources.
• Ensure the tree is positioned on surfaces with normal flammability (e.g., wood, masonry). Do not place on highly flammable surfaces like polystyrene or textiles.
• Position cables and extension leads to avoid hazards to children, pets, or the elderly.
• Do not cover the light set with curtains, nets, or bedding.
• The light source is non-replaceable. When the light source reaches the end of its life, the whole luminaire must be replaced.
• Do not connect the tree to the power supply while it is still in the packaging.
• Do not interconnect parts of this lighting chain with parts of another manufacturer's lighting chain.