User Manual for Anko Make Your Own Craft Kits

Quick guide from the manual

This manual provides assembly instructions for four different Anko craft kits: Charm Keyring, Charm Bracelets, Sparkle Gem Art, and Squishy Bear. Please ensure adult supervision for children, especially regarding small parts and choking hazards.

Safety Warnings

• Choking Hazard: Contains small parts. Not suitable for children under 3 years.
• Imitation Food: Not for human consumption.
• Glue Safety: Glue may cause stains. Always protect clothes and work surfaces. If glue gets in eyes, rinse immediately and seek medical attention.

Make Your Own Charm Keyring

1. Fold the cord in half, placing one end over the other.
2. Loop the top cord over the bottom cord, then pull it through the loop and out.
3. Thread the large alphabet beads sequentially through the knotted cord and tie a knot at the end.
4. Clip the chain links together in sequence.
5. Thread the acrylic flower charm onto the ball chain.
6. Thread the beads onto one of the cords.
7. Once threaded, loop the end and tie a knot.
8. Pull the knot tight and thread the other side in the same way.
9. Clip the assembled chains onto the keychain clip.

Make Your Own Charm Bracelets

1. Select your favorite beads and string them onto the elastic string one by one.
2. Tie a knot on the string.
3. Pull the knot tight.
4. Tie another knot in the same way.
5. Trim the excess string (scissors not included).
6. Attach the accessories to the metal rings.
7. Hang the accessories with the metal rings onto the strung bracelet.
8. Align the chain links with the openings one by one to connect them together.

Make Your Own Sparkle Gem Art

1. Remove the protective film from the wax square, and stick wax on the tip of the applicator pen.
2. Pick up the gems with the applicator pen.
3. Apply glue to the surface of the vinyl figurine.
4. Brush the glue evenly on the surface, then wait for about 15-30 seconds.
5. Place the gems on the vinyl figurine in the correct colour coded position.
6. Hook the keychain clip into the hole of your finished vinyl figurine.

Tips for Sparkle Gem Art

• If the gem sticks to the applicator pen and cannot be released, clean the pen tip with water.
• If the glue on the brush tip dries, soak the bristles in warm water for approximately 30 minutes to help dissolve the residue. Then, gently comb the bristles with your fingers and rinse until clean.
• Spread the glue in a thin, even layer. The glue should not be thick or uneven.

Make Your Own Squishy Bear

1. Put the squishy bear into the printed bag.
2. Adjust the position of the squishy bear.
3. Pour some sprinkles into the bag.
4. Pour some holographic mix-ins into the bag.
5. Put the pom poms into the bag.
6. Put the charms into the bag and adjust them to the appropriate position.
7. Seal the bag and attach the ball chain.