findmanualpdf.com

Avantco 193BC Series Refrigerated Display Case Temperature Reset Instructions

Quick guide for resetting the temperature range on Avantco 193BC and 360 series refrigerated display cases. Follow step-by-step instructions to adjust the controller settings.

Table of contents

Manual images

Click an image to enlarge
Step 1: Accessing parameter mode Page 1 Step 2: Entering setting mode Page 1 Step 3: Adjusting temperature Page 1 Step 5: Locking settings Page 1

Quick guide from the manual

This document provides instructions for resetting the temperature range on the controller for Avantco 193BC and 360 series refrigerated display cases. Follow these steps carefully to adjust the parameters.

Temperature Adjustment Procedure

Step 1: Accessing parameter mode
Step 1: Accessing parameter mode
Step 2: Entering setting mode
Step 2: Entering setting mode
Step 3: Adjusting temperature
Step 3: Adjusting temperature
Step 5: Locking settings
Step 5: Locking settings
  1. Access Parameter Mode: Press and hold the "▼" button for 10 seconds until the display shows "ON". This unlocks the controller for parameter adjustments.
  2. Enter Setting Mode: Press and hold the "SET" button for 6 seconds until the display flashes "E1".
  3. Adjust Temperature: Press the "▼" button repeatedly until you reach the desired set point of 32°F.
  4. Save Settings: Do not touch the controller for 10 seconds. The system will automatically save the new settings.
  5. Lock Settings: Press and hold the "▼" button for 10 seconds until the display shows "OFF". This locks the settings in place.
  6. Verify: Press the "SET" button again. The display will flash the temperature at which the compressor currently cycles off.

Important Operational Notes

The compressor will kick on approximately 7-8 degrees above the set point. Ensure you follow the timing (10 seconds, 6 seconds) precisely to enter and exit the programming modes correctly.

Manufacturer information

Avantco Equipment

Brand profile
Manufacturer website https://www.avantco.com Support https://www.avantco.com/support

Practical help

Common problems

Display does not show 'ON' after 10 seconds.

Ensure you are holding the '▼' button firmly for the full 10 seconds without interruption.

Settings are not saving.

After adjusting the temperature to 32°F, you must wait 10 seconds without touching the controller to allow the system to auto-save.

Before use

  • Ensure the unit is powered on.
  • Identify the 'SET' and '▼' buttons on the controller panel.
  • Verify the current temperature setting before making changes.

Specs in practice

Compressor Cycle
The compressor will activate approximately 7-8 degrees above the set point.

Images and diagrams

  • The controller panel features a digital display, a 'SET' button, and a '▼' (down arrow) button.
  • The display indicates the current status (ON/OFF) and temperature values during the adjustment process.

Model compatibility

  • Applicable to series: 193BC, 193BCT, 193CAC, 193HAC, 193MAC, 193VAC, 193VOA, 360BCC, 360BCDI, 360BCS, 360BCSS, 360CRR, 360GSM, 360RSD.

Related manuals

Related manuals from the same brand or category.

Manual page author

Michael Turner

Technical manual editor

Reviews PDF manuals for structure, safety notes, and practical product details so readers can find the right information quickly.