Lighting / Ceiling Fans
Globo Lighting 0390S Fan Remote Control
Quick guide for the Globo Lighting 0390S fan remote control. Learn how to install the receiver, operate the fan speeds, and replace batteries safely.
Table of contents
Quick guide from the manual
This document provides instructions for the Globo Lighting 0390S fan remote control. It covers the installation of the receiver, operation of the remote functions, and battery replacement procedures. Ensure the fan's pull chain is set to the highest speed before using the remote.
Safety Warnings
- Do not use this product with a wall-mounted dimmer switch.
- Ensure the main power supply is switched off at the circuit breaker before installation.
- The device must be installed by a qualified electrician.
- Do not exceed the maximum load: 100W for the light and 300W for the fan motor.
- The device is intended for indoor use only.
Installation
The receiver must be installed inside the fan canopy. Ensure the wiring is connected according to the provided diagrams. The receiver should be placed in the canopy, and the antenna should be kept outside the canopy for better signal reception.
Operation
The remote controls the light (On/Off) and the fan speed (High, Medium, Low, Off). To operate, press the corresponding button on the transmitter. If the fan speed does not change, ensure the manual pull chain on the fan is set to the highest speed position.
Battery Replacement
To replace the batteries, slide the battery cover down as shown in the diagrams. Use 1.5V AA batteries. Ensure correct polarity when inserting new batteries.
Manufacturer information
Globo Lighting
Practical help
Common problems
Remote not working
Check battery polarity and charge. Ensure the receiver is correctly wired and the antenna is not obstructed.
Fan speed not changing
Ensure the manual pull chain on the fan is set to the highest speed before using the remote.
Before use
- Turn off the main power supply at the circuit breaker.
- Ensure the fan pull chain is set to the highest speed.
- Verify that the receiver is placed inside the canopy.
- Check that the antenna is positioned correctly for signal reception.
Specs in practice
- Max Load (Light)
- 100W
- Max Load (Fan Motor)
- 300W
Images and diagrams
- Fig 1.1/1.2: Shows the correct placement of the receiver inside the fan canopy.
- Fig 3/4: Illustrates the battery compartment access and replacement procedure.
Model compatibility
- Not compatible with wall-mounted dimmer switches.
- Designed for indoor use only.
Manual page author
David Miller
Documentation analyst
Organizes user manual content into clear summaries, with attention to model details, product context, and everyday usability.