Tools / Power Tools
HiKOKI CR 18DBL Cordless Reciprocating Saw User Guide
Quick guide for the HiKOKI CR 18DBL cordless reciprocating saw, covering safety, operation, blade selection, battery maintenance, and troubleshooting.
Table of contents
Quick guide from the manual
This document provides essential instructions for the safe and efficient operation of the HiKOKI CR 18DBL cordless reciprocating saw. Always read the full safety warnings before use. Key operations include battery installation, blade mounting, and mode selection.
Device description
The tool features a handle, trigger switch, lock-off button, housing, front cover, lever for blade release, blade, base, LED light, base lever, battery, and a hook for temporary storage.
Operation
To operate, ensure the battery is firmly installed. Use the trigger switch to start the tool. The tool features a mode selector switch to toggle between speed change modes (Low, Medium, High) and an Auto mode, which adjusts speed based on load. Caution: Do not cut stainless steel in Auto mode.
Blade mounting and removal
To mount, insert the blade into the blade hole. To remove, pivot the lever and point the blade downward; it should fall out. If broken, use the tip of another blade to hook and remove the broken piece from the slit.
Battery and charging
Charge the battery using the specified charger. The pilot lamp indicates the charging status: blinking red (before charging), continuous red (charging), blinking red (charging complete), flickering red (malfunction), or green (overheat standby). Always allow the battery to cool if it is hot before charging.
Maintenance
Regularly inspect the blade for wear and ensure all mounting screws are tight. Clean the exterior with a soft, dry cloth or soapy water. Do not use solvents that melt plastic. Store in a cool, dry place below 40°C.
Safety
Always wear eye protection. Keep the work area clean and well-lit. Do not use the tool in explosive atmospheres. Hold the tool by insulated gripping surfaces when cutting near hidden wiring. Use clamps to secure the workpiece.
Manufacturer information
HiKOKI
Practical help
Common problems
Motor stops during operation
This is likely the protection function. If the battery is empty, charge it. If overloaded, release the switch and eliminate the cause of overload. If overheated, let the battery cool down.
Pilot lamp flickers red (0.2s intervals)
Check for foreign objects in the charger's battery connector. If none, the battery or charger may be malfunctioning; contact an authorized service center.
Pilot lamp flickers green (0.2s intervals) when using in-car charger
The car battery voltage is 12V or lower, indicating it is too weak to charge.
Before use
- Ensure the work area is clean and well-lit.
- Check that the switch is in the OFF position before inserting the battery.
- Verify the blade is securely mounted.
- Ensure the battery is fully charged.
- Check that all guards are in place.
Specs in practice
- No-Load Speed
- 0 – 2500 min-1
Model compatibility
- Use only genuine HiKOKI batteries.
- Do not use stainless steel in Auto mode.
- Use appropriate cutting fluid for metallic materials.
Manual page author
Michael Turner
Technical manual editor
Reviews PDF manuals for structure, safety notes, and practical product details so readers can find the right information quickly.