Plumbing / Sinks Faucets
Installation and User Guide for Sanela SLS 02PTA Piezo Button Shower Control
Quick guide for the Sanela SLS 02PTA piezo button shower control, covering installation steps, parameter settings, and maintenance requirements.
Table of contents
Quick guide from the manual
The Sanela SLS 02PTA is a piezo-controlled shower system with a thermostatic mixer, operating on 24 V DC. This document provides essential installation and configuration steps. Important: The unit must be kept under constant voltage; do not connect the power supply behind a light circuit switch. Ensure water pressure is between 0.1 and 0.6 MPa and that the sieve mesh size is ≤ 90 µm.
Installation
Installation must be performed by qualified personnel. Before starting, ensure you have read the safety instructions. The system requires a 24 V DC power supply. Follow the numbered steps in the manual for mounting the wall box, connecting the water supply (hot/cold), and wiring the piezo button. Ensure the wall is tiled correctly, leaving a 0-6 mm gap for the installation frame.
Parameter settings
Parameters can be adjusted using the SLD 04 remote control. Key adjustable settings include:
- Automatic stop: Factory setting is 120 s (adjustable 10-310 s).
- Hygienic flush interval: Factory setting is OFF (adjustable OFF/6/8/12/24/48/72/168 h).
- Hygienic flush duration: Factory setting is 5 s (adjustable 5-1200 s).
Maintenance
Regular maintenance is recommended. To perform maintenance, shut off the water supply using the integrated valves. Ensure the power supply remains constant for proper operation. For technical support or service, contact your installation company or visit the official website at www.sanela.eu/service.
Official resources from the manual
Manufacturer information
SANELA spol. s r. o.
Practical help
Common problems
Unit not functioning
Ensure the unit is under constant voltage and not connected behind a light switch.
Water flow issues
Check that the water pressure is within the 0.1 - 0.6 MPa range and the sieve is clean (mesh size ≤ 90 µm).
Before use
- Verify 24 V DC power supply is connected correctly (brown +, white -).
- Ensure water pressure is between 0.1 and 0.6 MPa.
- Check that the sieve mesh size is ≤ 90 µm.
- Confirm the unit is not connected to a switched light circuit.
- Ensure the wall tiling gap is within 0-6 mm.
Model compatibility
- Requires SLD 04 remote control for parameter adjustments.
- Compatible with various Sanela power supplies (SLZ 01Y, 01Z, 04Y, 04Z, 04X, 06).
Manual page author
Emily Carter
User documentation editor
Prepares concise manual descriptions and highlights the most useful setup, operation, and maintenance information for readers.