Installation Guide for Satco Hi-Pro LED Lamps

Quick guide from the manual

This document provides installation and safety instructions for Satco Hi-Pro LED Lamps (120-277V). Installation must be performed by a qualified electrician in accordance with local and national electrical codes. The retrofit kit is intended for use as a component of a luminaire where the suitability of the combination is determined by authorities having jurisdiction.

Important safety warnings

• Risk of Fire or Electric Shock: Disable all power to the luminaire before starting.
• Qualified Personnel: Installation requires knowledge of luminaire electrical systems. If not qualified, do not attempt installation.
• Emergency Exit: This device is not intended for use with emergency exit fixtures.
• Damage Prevention: Do not expose wiring to edges of sheet metal or sharp objects. Do not make or alter any open holes in the wiring enclosure.
• Inspection: Examine all parts for damage before installation. Do not use if the outer lamp envelope is damaged or broken.

Installation and wiring

The installation process involves disconnecting the existing lamp holder from the ballast, capacitor, or ignitor. Installers should not disconnect existing wires from lampholder terminals to make new connections; instead, cut existing lampholder leads away from the lampholder and make new electrical connections using applicable connectors.

Ensure the input rating of the retrofit kit does not exceed the input rating of the luminaire.

Compliance

This device complies with part 15 of the FCC Rules. Operation is subject to the condition that the device does not cause harmful interference and must accept any interference received. If interference occurs, try reorienting the receiving antenna, increasing separation, or connecting to a different circuit.