Lighting / Fixtures
Tecnolite 12TIRLEDCCTMVCTR5M LED Strip Instruction Manual
Quick guide for the Tecnolite 12TIRLEDCCTMVCTR5M LED strip. Includes installation steps, remote control operation, safety warnings, and technical specifications.
Table of contents
Manual images
Jump to the sectionQuick guide from the manual
This document provides essential instructions for the installation and operation of the Tecnolite 12TIRLEDCCTMVCTR5M LED strip. Key requirements include maintaining a minimum distance of 0.50 m from combustible materials and ensuring the power adapter and IR controller are kept indoors, as they are rated IP:20.
Package contents
- A-01 Remote control
- A-02 Power adapter
- A-03 IR controller
Installation
- Connect the power adapter (A-02) to the IR controller (A-03).
- Align the LED strip connector with the IR controller output.
- Ensure the IR receiver is positioned to receive signals from the remote control.
- The LED strip can be cut every 3 LEDs at the marked points.
- Use the adhesive backing for mounting. Ensure a minimum bending radius of 25mm.
Operation
Use the remote control (A-01) to manage the lighting:
- ON-OFF: Power the strip on or off.
- CCT Change: Press to cycle through 9 color temperature levels.
- Flash: Quick change for neutral and daylight settings.
- Flash Speed: Press to cycle through 8 speed levels.
- Dimming: Adjust brightness levels.
Safety and maintenance
- Disconnect power before installation or maintenance.
- Clean the luminaire and internal parts with a dry rag.
- Do not use the device if you have physical or mental impairments; children should be supervised and not use the device as a toy.
- The power adapter and controller are not for outdoor use.
Technical specifications
- Input: 100 V - 240 V ~ 50/60 Hz 300 mA
- Output: 12 V --- 1 A
- Power: 12 W
Manufacturer information
Tecnolite
Practical help
Common problems
Strip does not respond to remote
Ensure the IR receiver is not obstructed and is properly connected to the controller.
Power adapter or controller failure
Verify that the components are not being used outdoors, as they are rated IP:20 and not weather-resistant.
Before use
- Ensure the installation surface is clean for the adhesive backing.
- Check that the power source matches the 100-240V input requirement.
- Verify that the LED strip is not bent at a radius smaller than 25mm.
- Confirm that the power adapter and controller are kept in a dry, indoor environment.
Images and diagrams
- Step 1: Remote control button layout and functions.
- Step 2: Connection sequence between power adapter, IR controller, and LED strip.
- Step 3: Cutting instructions (every 3 LEDs) and mounting precautions.
Model compatibility
- The power adapter and IR controller are strictly for indoor use.
- The LED strip can be customized by cutting at designated intervals.
Manual page author
David Miller
Documentation analyst
Organizes user manual content into clear summaries, with attention to model details, product context, and everyday usability.