User Guide for Uniview 0235UNUW Dual-Lens Video Doorbell

Quick guide from the manual

This document provides essential instructions for installing and configuring the Uniview 0235UNUW Dual-Lens Video Doorbell. Key procedures include physical installation, wiring for mechanical or wireless chimes, and network setup via the Guard Live app. Always disconnect power before installation.

Product Overview

The doorbell features a main camera, sub-camera with illuminators, microphone, speaker, doorbell button, and a reset button. A disassembly clip is located on the device for removal from the bracket using the provided detaching pin.

Installation

Preparation: Install the doorbell on a wall near the main gate, ideally close to the router to ensure a strong Wi-Fi signal. Recommended installation height is 1.2m from the center of the drill template to the ground.

Mounting Steps:

• Choose the appropriate bracket (flat or inclined) based on the desired viewing angle.
• Use the drill template to mark and drill two holes (depth at least 25mm, diameter 6mm to 6.5mm).
• Insert expansion tubes and secure the bracket to the wall using the provided screws.
• Align the doorbell with the bracket and press until it clicks into place.

Wiring and Power Kit

Power Requirements: The device requires 12V AC to 24V AC power.

Mechanical Chime: If using a mechanical chime, the included Power Kit is required. Connect the Power Kit connection cables to the TRANS and FRONT terminals inside the mechanical chime, then place the Power Kit inside the chime housing.

Wiring: Connect the doorbell power cables to the external power source. For mechanical chimes, connect the U-shaped connectors to the doorbell terminal screws.

Network Configuration and Pairing

Initial Setup: Download the Guard Live app. Upon first startup, the doorbell automatically enters network configuration mode. If needed, press and hold the doorbell button for 2 seconds to trigger configuration.

Pairing: Use the app to scan the activation code on the back of the doorbell or the guide cover. To pair with a chime, navigate to Chime Settings > Add Chime in the app.

Status Indicators

The LED indicator provides feedback on the device status:

• Steady red: Restoring factory defaults.
• Blinking red (once/sec): Wi-Fi connection failed.
• Blinking green (once/sec): Ready for network configuration.
• Blinking green (twice/sec): Connected to P2P or Wi-Fi.
• Blinking green (slowly): Making a call.
• Steady green: Call answered or device added successfully.

Safety and Maintenance

Reset: Press and hold the reset button until you hear a beep, then release. Wait for the indicator to flash red to confirm a successful reset.

Detaching: Always disconnect power before detaching the doorbell. Use the supplied detaching pin to press the disassembly clip and remove the device from the bracket.

Safety: The device must be installed by a trained professional. Ensure proper ventilation, protect from liquids, and do not stack devices.