User Guide for Uniview 0235C9A1 Network Dome Camera

Quick guide from the manual

This document provides essential instructions for installing and configuring the Uniview 0235C9A1 Network Dome Camera. Key procedures include proper cable waterproofing, physical mounting, and network setup via the Guard Live app or web interface.

Waterproof Requirements

Proper waterproofing is critical to prevent device damage. Follow these steps:

• Connect all necessary cables and cut off unused copper wires.
• Use insulation tape to insulate the connection part of each cable.
• Apply self-adhesive waterproof tape: fully stretch the tape at both ends, wrap the connection part and cable ends tightly, and tighten the tape at both ends.
• Install the supplied waterproof components to the network cable in sequence.
• Caution: Mount the rubber ring onto the network cable interface first.
• Optionally, place cables into a waterproof junction box.

Packing List

Ensure the package contains the following items. Contact your dealer if anything is missing:

• Camera
• Power adapter
• Waterproof components (tape, plug)
• Screw components (screws, hex key)
• Mount accessories (drill template, bracket adapter, antistatic gloves)
• Product documents
• Bracket

Appearance and Connections

The camera features a network interface and a power interface. The actual appearance and tail cable may vary by model. Ensure the cable connector is kept away from water and exposed elements.

Mounting the Camera

Micro SD Card Installation

1. Use a screwdriver to remove the two screws on the card cover.
2. Remove the cover and insert the Micro SD card into the slot.
3. Replace the cover and tighten the screws. Ensure the sealing ring is in position.
4. Format the Micro SD card via the camera's web interface before use.

Wall Mount

1. Locate hole positions and drill holes on the wall.
2. Hammer expansion bolts into the holes and ensure they are tightened.
3. Lead cables out from the bottom of the bracket and fix the bracket to the wall using four ST3.5 self-tapping screws.
4. Align the camera gear with the bracket gear, keep the camera upright, and tighten the M4 screw.
5. Connect all cables and apply waterproof measures.

Startup and App Configuration

Connect the power adapter to the mains and the device. To add the camera to the Guard Live app:

• Ensure your phone is connected to a 2.4GHz Wi-Fi network.
• Download and install the Guard Live app.
• Sign up for an account and log in.
• Open the app, tap the plus icon or Add Device, and scan the registration QR code.
• Follow the in-app instructions to complete the Wi-Fi connection.
• If registration fails, press and hold the reset button for 10 seconds within 10 minutes of powering on the device.

Web Interface Access

You can access the camera via a web browser:

• Default IP address: 192.168.1.13
• Default username: admin
• Default password: 123456
• Security Note: Change the default password immediately after the first login. Use a strong password of at least nine characters, including digits, letters, and special characters.
• You may need to install a plug-in upon the first login.

Security and Safety

To enhance network security, it is recommended to:

• Keep firmware updated.
• Change passwords regularly.
• Enable HTTPS/SSL.
• Disable unused features like UPnP, SNMP, and Multicast.
• Isolate the video surveillance network.
• Ensure the device is installed by a trained professional.