User Manual for Anker 625 Solar Panel 100W

Quick guide from the manual

The Anker 625 Solar Panel (100W) is designed to convert sunlight into electrical energy. It does not store electricity itself, so it must be connected to a power bank, a PowerHouse, or a device directly. For maximum charging efficiency, the panel must be aligned directly with the sun using the integrated Suncast alignment tool.

Using Your Product

Follow these steps to set up and use your solar panel:

1. Unfold: Unfold the PowerSolar panel completely.
2. Support: Use the built-in legs to prop the panel up at an angle.
3. Align: Use the Suncast tool to align the panel with the sun. When the shadow of the blue dot is centered inside the red circle, the panel is capturing direct rays for maximum charge.
4. Connect: Charge your phone or tablet using the USB-A or USB-C ports. To charge a PowerHouse, use the XT60 port.
5. Verify: If the solar panel is working correctly, the LED indicator will turn blue.

Important Notes

• No Internal Storage: The solar panel cannot store electricity. You must connect it to a power bank or device to charge.
• Charging Efficiency: Performance is subject to sunlight intensity.
• Device Safety: Keep phones and tablets away from direct sunlight while charging to prevent damage from excessive heat.
• Power Output: The 100W rating refers to the solar panel's capacity, not the output of the ports. Actual output will be lower due to energy conversion loss.

Specifications

• Peak Power: 100W
• Rated Voltage: 26.5V
• Rated Current: 3.77A
• USB-A Output: 5V 2.4A
• USB-C Output: 5V 3A
• Size (folded): 525 x 470 x 85 mm
• Size (unfolded): 1446 x 525 x 45 mm
• Weight: 5 kg

Important Safety Instructions

• Avoid dropping the product.
• Do not disassemble the unit.
• Do not expose the product to liquids.
• Use original or certified cables for the safest and fastest charging.
• Do not place open flame sources, such as candles, near the product.

Maintenance

Only use a dry cloth or brush to clean this product.