Industrial / Door Controls
User Guide for BEA 10PBS2Gx Series Pushplate
Quick guide for the BEA 10PBS2Gx Series Pushplate. Includes installation steps, wiring instructions, cleaning procedures, and technical support contact information.
Table of contents
Quick guide from the manual
The BEA 10PBS2Gx Series Pushplate is designed for use with standard double-gang electrical boxes. It can be hard-wired to door operators or connected to B.E.A. radio-controlled transmitters. This guide provides essential installation and maintenance steps.
Installation Instructions
Follow these steps to install the pushplate:
- Wire the switches of the pushplate to the door controllers or radio-controlled transmitters. Ensure you use the NC (Normally Closed) contacts and common.
- Fasten the pushplate to the double-gang electrical box (not included) using the enclosed #6-32 x 1 inch screws.
- Test the pushplate for proper activation.
Cleaning and Maintenance
The faceplates are constructed with stainless steel and feature a scuff-resistant coating. To clean the plates, use only a damp, non-abrasive cloth. Do not use harsh solvents or abrasive materials, as these may cause the coating to deteriorate.
Technical Support
If you encounter a problem that cannot be resolved, contact B.E.A., Inc. for assistance. If you must wait for the next workday to call, leave the door inoperable until repairs are made to ensure safety.
Contact numbers (Eastern Standard Time):
- 7am - 5pm: 1-800-523-2462
- 5pm - midnight & weekends: 1-800-407-4545
Manufacturer information
BEA Sensors
Practical help
Common problems
Door remains inoperable after troubleshooting
Call BEA technical support immediately. Do not leave the door in an unsafe state; leave the door inoperable until satisfactory repairs can be made.
Before use
- Ensure the electrical box is a standard double-gang box.
- Verify compatibility with the door controller or radio transmitter.
- Have #6-32 x 1 inch screws ready for mounting.
- Use a damp, non-abrasive cloth for cleaning.
Specs in practice
- Double-gang box
- Standard electrical box size required for installation.
Images and diagrams
- The wiring diagram shows the connection points for COM, NO, and NC terminals.
- The installation diagram illustrates the mounting of the faceplate to the electrical box using screws.
Model compatibility
- Compatible with standard double-gang electrical boxes.
- Can be hard-wired to door operators or connected to B.E.A. radio-controlled transmitters.
Manual page author
David Miller
Documentation analyst
Organizes user manual content into clear summaries, with attention to model details, product context, and everyday usability.