Lighting / Fixtures
Instruction Manual for Crystorama 2016-AG Chandelier
Quick guide for the Crystorama 2016-AG chandelier. Includes assembly instructions, bulb requirements, parts list, and safety warnings for installation.
Quick answers from the manual
Quick answer
- The Crystorama 2016-AG is a four-light chandelier. Assembly requires two people. It uses 4 candelabra base bulbs (40W recommended, 60W max). p. 1
Key actions
- Install metal band onto acrylic ball p. 1
- Attach upper and lower metal caps p. 1
Technical specifications
| Parameter | Value | Meaning | Pages |
|---|---|---|---|
| Bulb Type | 4-Cand | Candelabra base | p. 1 |
| Max Wattage | 60W | Maximum wattage per bulb | p. 1 |
Show 1 more answers Show less
Where to find it in the PDF
- Assembly Instructions p. 1
- Parts List p. 2
Table of contents
Important Information
The Crystorama 2016-AG is a four-light chandelier. It is strongly recommended that 2 people complete the assembly of this item to ensure safety and proper alignment. This fixture is DRY rated, meaning it is suitable for indoor use in dry locations only.
Safety Warnings
- All electrical components must be installed by a licensed electrician in accordance with the National Electric Code and appropriate local electrical codes.
- Turn off power before beginning installation.
- This product contains materials known to the State of California to cause cancer and/or birth defects or reproductive harm (Lead).
Bulb Requirements
This fixture requires 4 candelabra base bulbs (4-Cand). The recommended wattage is 40 Watts, with a maximum of 60 Watts per bulb. LED bulbs are recommended for extended use. Bulbs are not included.
Installation Instructions
- Rest the acrylic ball inside the foam block included in the packaging.
- Install the metal band onto the acrylic ball. Hold the metal band straight while another person secures it on the acrylic ball with the provided screws.
- Unscrew the decorative nut.
- Install the bulbs into the socket.
- Attach the lower metal cap and socket cluster into the acrylic ball.
- Attach the upper metal cap onto the acrylic ball and secure using the decorative nut.
Parts List
The fixture includes the following components:
- Mounting Hardware: Wire nuts, wall anchors, anchor screws, screws, mounting plate, green ground screw.
- Structure: Canopy, rods (12" and 3"), decorative nut, upper and lower metal caps, light cluster, metal band, ball nuts, screws, top and bottom Lucite balls, and finial.
Manufacturer information
Crystorama
Practical help
Common problems
Difficult assembly
It is strongly recommended that 2 people complete the assembly of this item.
Bulb wattage exceeded
Use max 60W bulbs; 40W is recommended.
Before use
- Ensure power is turned off at the source
- Verify all parts are present according to the parts list
- Have a second person available for assembly
- Check that the installation location is dry (DRY rated)
Show more Show less
Images and diagrams
- The sketch map shows the assembly order of the metal bands and caps onto the acrylic ball.
- The parts diagram identifies all hardware, rods, and caps for correct installation.
Model compatibility
- This fixture is DRY rated.
Manual page author
David Miller
Documentation analyst