User Manual for Electro Harmonix POG2 Polyphonic Octave Generator Pedal

Quick guide from the manual

The POG2 is a polyphonic octave generator capable of mixing your dry signal with four different octaves (two above and two below). It features programmable presets, attack envelope control, and a resonant low-pass filter. Important: Use only the supplied 9.6 VDC 200mA power adapter. The unit does not use batteries.

Controls and Operation

The POG2 uses a series of sliders to shape your sound:

• DRY OUTPUT: Adjusts the volume of your original signal.
• Octave Sliders (-2, -1, +1, +2): Control the volume of each generated octave signal.
• ATTACK: Controls the attack envelope; pushing it upward creates a swell or reverse effect.
• LP FILTER: Adjusts the cutoff frequency of the low-pass filter.
• DETUNE: Adjusts the detune amount for the +1 and +2 octave signals.

DRY FX Modes

The DRY FX button cycles through four modes for the dry signal:

• Off: Dry signal bypasses all effects.
• RED: Dry signal goes through Attack, bypasses Filter and Detune.
• GREEN: Dry signal goes through Attack and Filter, bypasses Detune.
• AMBER: Dry signal goes through all three effects.

Presets

The POG2 can store and load up to 8 presets. The state of the BYPASS footswitch is not saved.

• Saving: Set your desired sound, then press and hold the white PRESET knob for 3 seconds until the LEDs stop blinking.
• Loading: Use the PRESET knob to select a number and press it, or use the PRESET footswitch to cycle through saved presets.

Technical Specifications

• Input Impedance: 2 MΩ.
• Output Impedance: Approximately 800 Ω.
• Power Requirements: 9 VDC, 180 mA, center negative plug.