Lighting / Controllers & Dimmers
User Manual for Enerlites 55300 Dimmer
Quick guide for the Enerlites 55300 dimmer switch. Includes wiring diagrams for single-pole and 3-way installations, adjustment instructions, and load capacity specifications.
Table of contents
Manual images
Click an image to enlargeQuick guide from the manual
The Enerlites 55300 is a dimmer switch designed for incandescent, halogen, dimmable LED, and CFL bulbs. It supports both single-pole and 3-way wiring configurations. Before installation, always turn off the power at the circuit breaker. The device features a rocker switch for power, a slider for light level control, and a tuning dial for fine-tuning the lowest light output.
Safety Warnings
- Turn off power at the circuit breaker or fuse before starting installation.
- Use copper wire only.
- Installation should be performed by a qualified electrician in accordance with the National Electric Code and local regulations.
Specifications
- Voltage: 120VAC, 60Hz
- Incandescent/Halogen Load: 600W max
- Dimmable LED and CFL Load: 200W max
- Operating Temperature: 32°F to 104°F
Wiring Instructions
Single-Pole Wiring: Connect the HOT wire to the BLACK wire on the switch. Connect the load wire to the uninsulated RED wire. Connect the GROUND wire to the GREEN wire.
3-Way Wiring: Remove the insulating label from the red wire. Connect the HOT wire to the BLACK wire. Connect each RED wire to separate TRAVELER wires. Connect the GROUND wire to the GREEN wire.
Dimmer Adjustment
Use the rocker switch to turn lights on/off. Use the slider to set the light level. To fine-tune the lowest light level, turn the Tuning dial upwards or downwards until the desired level is reached. Do not overturn the dial. If bulbs do not turn on, turn the adjustment dial up until they do.
Multigang Installation
When installing multiple controls in one wall box, you may need to remove the side tabs using pliers. Bend each tab back and forth until they break off. Note that removing these tabs reduces the maximum load capacity of the dimmer.
Practical help
Common problems
Lights do not turn on
Turn the adjustment dial up until all lights come on. Some dimmable CFLs and LEDs require at least two bulbs or 10W total wattage on one lamp for proper operation.
Lowest light level is flickering or unstable
Use the Tuning dial to adjust the lowest light level until the desired level is reached. Do not overturn the dial.
Reduced load capacity
Removing side tabs for multigang installation reduces the maximum load capacity. Check the de-rating chart in the manual if using multiple dimmers.
Before use
- Turn off power at the circuit breaker.
- Verify compatibility with LED, CFL, Incandescent, or Halogen bulbs.
- Ensure you are using copper wire only.
- Identify if you need Single-Pole or 3-Way wiring.
- Ensure you have a qualified electrician for installation.
Images and diagrams
- Figure 1: Single-Pole Wiring diagram showing connections for Hot, Load, Ground, and Neutral.
- Figure 2: 3-Way Wiring diagram showing connections for Hot, Load, Ground, and two Traveler wires.
Model compatibility
- Compatible with Incandescent, Halogen, Dimmable LED, and Dimmable CFL.
- Only one dimmer is needed for each 3-way application.
Manual page author
Emily Carter
User documentation editor
Prepares concise manual descriptions and highlights the most useful setup, operation, and maintenance information for readers.