Documents / Warranty Safety
User Manual for FlinQ 18V Cordless Drill
Quick guide for the FlinQ 18V Cordless Drill, covering setup, operation, safety instructions, maintenance, and technical specifications.
Table of contents
Quick guide from the manual
This document provides essential instructions for the safe and effective use of the FlinQ 18V Cordless Drill. Before first use, ensure you have read all safety warnings. The tool is designed for inserting/loosening screws and drilling into wood, metal, ceramics, and plastics. It is not intended for very hard materials like concrete or cement.
Device description
The drill features a keyless metal chuck, torque selection, 2-speed gear selection, rotation direction switch, and an integrated LED work light. Note that the battery pack and charger are not included in the scope of delivery.
Operation
- Gear selection: Use the gear switch only when the tool is at a complete standstill. 1st gear is for screwing (low speed, high torque); 2nd gear is for drilling (high speed, low torque).
- Rotation direction: Adjust using the switch. The middle position locks the on/off trigger.
- Torque control: Adjust the torque selection ring based on the material and screw size. Use the drill position for drilling operations.
- Speed control: The on/off switch allows for progressive speed regulation based on pressure applied.
Maintenance and cleaning
Always remove the battery pack before performing any maintenance. Clean the tool with a dry cloth and a soft brush for vents. Do not use aggressive chemicals. Store in a dry, frost-free, and well-ventilated place. For long-term storage, keep the battery charged between 40% and 60% and check it every 3 months.
Safety
Always wear protective equipment, including eye protection and gloves. Be aware that the tool generates an electromagnetic field, which may interfere with medical implants. If the tool malfunctions, stop use immediately and contact a qualified professional.
Manufacturer information
FlinQ
Practical help
Common problems
Tool does not run smoothly or vibrates excessively
Switch off immediately, check if the accessory is centered in the chuck, and ensure it is not damaged.
Battery pack not charging or status LEDs flashing
If green and red LEDs flash, the battery is defective. If red LED flashes, the battery is too cold or too warm.
Drill bit bending or breaking
Ensure you are not applying excessive pressure and are using the correct speed for the material and bit size.
Before use
- Ensure the battery pack is charged (40-60% for storage, full for use).
- Check that the accessory tool is correctly centered and tightened in the keyless chuck.
- Verify the rotation direction switch is set to the desired direction.
- Ensure the gear selection is fully engaged.
- Wear appropriate personal protective equipment (gloves, eye protection).
Specs in practice
- Torque settings 23+1
- 23 settings for precise screw driving control plus 1 dedicated setting for drilling.
- Speed level 1 (0-400 rpm)
- Low speed range, ideal for high-torque applications like driving large screws.
- Speed level 2 (0-1600 rpm)
- High speed range, ideal for drilling applications.
- Max. drilling diameter
- Maximum capacity is 30mm in wood and 13mm in metal.
Model compatibility
- Charger is only compatible with FlinQ battery packs FQC8516 (2.0 Ah) and FQC8517 (4.0 Ah).
- Not intended for drilling into cement or concrete.
Manual page author
David Miller
Documentation analyst
Organizes user manual content into clear summaries, with attention to model details, product context, and everyday usability.