Installation Guide for Hinkley 1504BZ Carson LED Path Light

Quick Guide

The Hinkley 1504BZ Carson LED Path Light is designed for 12V landscape lighting systems. Ensure you are using Hinkley-approved equipment to prevent premature failure. The installation requires basic wiring skills and proper connection using the provided silicone-filled wirenuts.

Safety Instructions

• The lamp gets hot quickly; do not touch the lens, guard, or enclosure while in operation.
• Keep the lamp away from flammable materials.
• Do not operate the luminaire if the shield is missing or damaged.
• Do not install within 10 feet (3m) of a pool, spa, or fountain.
• Always disconnect the transformer from the electrical supply before installation or service.

Installation

1. Find a clear area for installation.
2. Disconnect the transformer from the power supply.
3. Run the wire from the luminaire through the mounting hole in the top of the ground stake.
4. Attach the luminaire to the ground stake by threading it until it fits snugly against the bottom of the stem.
5. Insert the stake into the ground until the flange is flush with the surface.
6. Strip the two wire leads and connect them to the main supply wire using the provided silicone-filled wirenuts.

Wiring

The main secondary wire is intended for shallow burial (less than 6 inches / 15.2cm). Ensure the wire is routed in close proximity to the luminaire or a building structure. The wire should be cut so that it connects to a connector within 6 inches of a building structure or the luminaire.