Furniture / Bathroom Furniture
Assembly Instructions for Home Decorators Collection Beverly 24 in. W Mirror
Quick guide for the Home Decorators Collection Beverly 24-inch mirror. Includes assembly steps, tools required, safety warnings, and maintenance tips.
Quick answers from the manual
Quick answer
- This manual provides assembly and installation instructions for the Home Decorators Collection Beverly 24-inch mirror, including tools required and maintenance tips. p. 1, 7
Key actions
- Measure the distance between keyholes on the back panel before drilling holes in the wall. p. 7
- Leave 5/16 inches of the screw exposed when installing into the wall to allow the mirror to hang. p. 7
First start
- Ensure the wall is flat, drill holes based on keyhole spacing, insert plastic plugs, install screws leaving 5/16 inches exposed, and hang the mirror. p. 5, 7
Show 3 more answers Show less
Problems and fixes
The mirror is not level
Measure the hole well and re-drill.
p. 8Technical specifications
| Parameter | Value | Meaning | Pages |
|---|---|---|---|
| Weight Capacity | 50 lbs | Maximum weight the mirror can support. | p. 2 |
Where to find it in the PDF
- Assembly Instructions p. 7
Table of contents
Manual images
Click an image to enlargeQuick guide from the manual
This document provides instructions for the assembly and installation of the Home Decorators Collection Beverly 24-inch mirror. The mirror is designed for indoor use on flat, level surfaces. Please ensure you have all necessary tools before beginning the installation.
Safety information
- Weight limit: The product is designed to hold a maximum of 50 lbs. Exceeding this limit may cause damage or injury.
- Assembly: Adult assembly is required. Keep small parts away from children.
- Surface: Install only on a flat, level surface.
- Chemical warning: This product may expose you to chemicals including formaldehyde.
Tools and hardware
Tools required (not included):
- Electric drill with #2 drill bit
- Phillips screwdriver
- Tape measure
- Safety goggles
- Level
Hardware included:
- 2 Screws (AA)
- 2 Plastic plugs (BB)
Assembly instructions
Follow these steps to install your mirror:
- Measure and drill: Measure the distance between the keyholes on the back panel of the mirror. Mark these distances on the wall and drill holes accordingly.
- Insert plugs: Place the plastic plugs (BB) into the predrilled holes in the wall.
- Install screws: Rotate the screws (AA) into the plastic plugs (BB), ensuring you keep 5/16 inches of the screw exposed outside the wall to hang the mirror.
- Hang the mirror: Carefully hang the mirror (A) onto the installed screws.
Care and cleaning
- Dust the mirror frequently with a clean, soft, and dry cloth.
- Wipe away any water or liquid spills immediately with a clean, soft, and dry cloth.
- Avoid placing the mirror in direct sunlight or near heat/air vents to prevent damage to the finish.
Troubleshooting
If the mirror is not level, the hole on the wall may not be level. Measure the hole position again and re-drill as necessary.
Manufacturer information
Home Decorators Collection
Practical help
Common problems
The mirror is not level
Measure the hole position on the wall again and re-drill.
Before use
- Check all packing materials for small parts
- Ensure you have an electric drill with a #2 bit
- Verify the wall surface is flat and level
- Use a level to ensure accurate hole placement
Show more Show less
Specs in practice
- Weight Capacity
- The mirror is designed to support a maximum of 50 lbs.
Images and diagrams
- The assembly diagram illustrates measuring the distance between keyholes on the back of the mirror, drilling the wall, inserting plastic plugs, and installing screws with 5/16 inches of clearance for hanging.
Model compatibility
- For indoor use only.
- Must be installed on a flat, level surface.
Manual page author
Michael Turner
Technical manual editor