Lighting / Fixtures
Installation Manual for Resistex Skore 22552 Lighting Fixture
A comprehensive installation guide for the Resistex Skore 22552 LED luminaire. This manual covers safety precautions, mounting procedures, wiring diagrams for DALI control, and maintenance instructions.
Quick answers from the manual
Quick answer
- This manual provides installation and safety guidelines for the Resistex Skore 22552 LED luminaire, including mounting steps and wiring diagrams for DALI control. p. 1, 2
Key actions
- Mount the fixture using a 1300mm hole spacing. p. 2
- Connect the wiring to the terminal block, including L, N, Earth, and DALI terminals. p. 2
First start
- Ensure the power is disconnected before beginning the installation. p. 2
Show 2 more answers Show less
Maintenance and reset
- Clean the fixture with a dry cloth; do not use chemicals or abrasives. p. 1
Where to find it in the PDF
- Safety and Maintenance p. 1
- Installation Steps p. 2
Table of contents
Quick guide from the manual
This document provides essential installation and safety instructions for the Resistex Skore 22552 LED luminaire. The installation must be performed by a professional installer in compliance with local electrical regulations. The fixture supports DALI control.
Safety notes
- Never work on the luminaire while it is under voltage.
- The installation must be performed by a professional installer in compliance with standards and regulations relating to electrical installations.
- Risk of electrostatic discharge (ESD): Handle components with necessary precautions.
- Please observe the notes and steps described in the mounting instructions.
Installation instructions
Mounting
- Ensure the power supply is disconnected before starting.
- Prepare the mounting surface with a hole spacing of 1300mm.
- Secure the mounting brackets using appropriate hardware.
- Attach the fixture to the mounting brackets.
- Secure the fixture in place.
Wiring
The fixture includes connections for power and DALI control. Ensure wires are connected according to the following configuration:
- L: Phase
- N: Neutral
- Earth: Ground connection
- DA / DA: DALI control terminals
Complete the final assembly and ensure all connections are secure before restoring power.
Maintenance instructions
- Do not use chemicals or abrasive products to clean the fixture.
- Keep these instructions for dismantling or future maintenance.
- Additional information about Resistex luminaires can be found at www.resistex-sa.com.
Official resources from the manual
Practical help
Common problems
Fixture not working after installation
Verify that the power supply is connected correctly and that the DALI control signals are properly wired.
Electrostatic discharge risk
Handle the luminaire and its components with ESD precautions to prevent damage to internal electronics.
Before use
- Ensure the power supply is turned off.
- Verify that the mounting surface can support the weight of the fixture.
- Confirm the mounting hole spacing is exactly 1300mm.
- Ensure a professional installer is available for the electrical connection.
- Check that all necessary tools (drill, screwdriver) are available.
Show more Show less
Images and diagrams
- The wiring diagram illustrates the terminal block connections for Phase (L), Neutral (N), Earth, and two DALI terminals.
Model compatibility
- The fixture is designed for professional installation in compliance with electrical standards.
Manual page author
Emily Carter
User documentation editor