Installation and User Guide for Sanela SLSN 01E Automatic Shower Panel

Quick guide from the manual

The Sanela SLSN 01E is an automatic stainless steel shower panel designed for cold or premixed water. Key operational requirements include a 24V DC power supply and water pressure between 0.1 and 0.6 MPa. The unit features an infrared sensor for automatic activation, adjustable delay, and a safety shut-off function. Parameters such as flush duration and hygienic flush intervals can be configured using the SLD 03 remote control.

Product description

The SLSN 01E is a wall-mounted shower panel. It includes an integrated infrared sensor, a solenoid valve, and a flow regulator. The unit is constructed from stainless steel and is intended for indoor use. It requires a constant 24V DC power supply to function correctly.

Installation

Before installation, ensure the water supply is turned off and the area is prepared according to the technical drawing. The water inlet is G 1/2".

1. Drill holes according to the dimensions provided in the technical drawing (8 mm diameter).
2. Install the mounting bracket using the provided screws and wall plugs.
3. Mount the shower panel onto the bracket.
4. Connect the water supply to the inlet.
5. Flush the water supply line before final connection to remove debris.
6. Ensure the sieve (mesh size ≤ 90 µm) is clean and installed correctly.

Electrical connection

Important: The unit must be connected to a constant 24V DC power supply. Do not connect the power supply unit behind a light switch or any other switch that could interrupt the power, as this will cause the unit to malfunction.

• Connect the brown wire to the positive (+) terminal.
• Connect the white wire to the negative (-) terminal.
• Ensure all connections are secure and insulated.

Operation and settings

The shower activates automatically when a user enters the sensor range (0.3 - 0.7 m). The following parameters can be adjusted using the SLD 03 remote control:

• Shower activation delay: 0 - 15 seconds (Factory setting: 2 s).
• Time safety shut-off: 10 - 310 seconds (Factory setting: 300 s).
• Hygienic flush interval: OFF / 6 / 8 / 12 / 24 / 48 / 72 / 168 hours (Factory setting: OFF).
• Hygienic flush duration: 5 - 1200 seconds (Factory setting: 5 s).

Maintenance

Regular maintenance is required to ensure proper operation. If the water flow is insufficient, check the flow regulator. To replace the regulator:

1. Shut off the water supply.
2. Remove the shower head/regulator assembly.
3. Replace the regulator (part 10 or 11).
4. Reassemble and test for leaks.

For technical support or service, contact the installation company or visit www.sanela.eu/service.