Plumbing / Toilets Urinals
Sanela SLKA 01W Sanitary Cabin Maintenance Guide
Essential maintenance and cleaning guide for Sanela SLKA 01W sanitary cabins, covering DTDL wall panels and stainless steel hardware care.
Table of contents
Quick guide from the manual
This document provides essential maintenance and cleaning instructions for Sanela SLKA 01W sanitary cabins. Proper care is required to maintain the surface integrity of DTDL panels and stainless steel hardware. Note that cabins with DTDL wall panels are not designed for high-humidity environments; keep surfaces dry at all times.
Cleaning DTDL wall panels
The DTDL panels (18 and 25 mm thickness) should be cleaned using paper towels, soft textile cloths (dry or damp), or a sponge. If cleaned with a damp cloth, the surface must be dried immediately with an absorbent paper towel or microfiber cloth. Hot water, common household liquid cleaners, or curd soap may be used.
- Always use non-abrasive cleaning agents.
- After cleaning, wipe the surface with clean water to remove all detergent residue to prevent streaks.
- Dry the surface thoroughly after rinsing.
Cleaning stainless steel hardware
Use soft cloths or sponges for cleaning. For greasy surfaces, use soapy water or a mild detergent, ensuring all residue is removed afterward. For limescale, use diluted vinegar. Professional stainless steel cleaners that leave a protective silicone film may also be used.
Important: Some hardware components have a brushed finish; always wipe in the direction of the grain lines.
Prohibited cleaning methods
To prevent irreversible damage, do not use the following on any part of the cabin:
- Abrasive powders or scouring pads with a rough side
- Steel wool
- Polishing agents
- Furniture cleaners
- Bleaching agents
- Strong acids or acidic salts
- Steam cleaning devices
- Colored cleaning agents
- Chlorine-based products (strictly prohibited for stainless steel)
Contact information
SANELA spol. s r. o., Dukelských hrdinů 989, 563 01 Lanškroun. Tel: +420 465 350 770-1, +420 725 970 202. Email: [email protected]. Website: www.sanela.cz
Official resources from the manual
Manufacturer information
SANELA spol. s r. o.
Practical help
Common problems
Streaks on DTDL surfaces
Ensure all detergent residue is removed by wiping with clean water and drying immediately with an absorbent cloth.
Limescale buildup on hardware
Use diluted vinegar to clean the affected areas.
Greasy stainless steel hardware
Use soapy water or a mild detergent, then rinse thoroughly.
Before use
- Verify that the cleaning agent is non-abrasive.
- Check that no chlorine-based products are used on stainless steel.
- Ensure you have soft textile cloths or paper towels available.
- Confirm that the cleaning area is not a high-humidity environment if using DTDL panels.
Specs in practice
- DTDL panel thickness
- The panels are 18 mm or 25 mm thick and require specific non-abrasive care.
- Brushed finish
- Hardware with this finish must be wiped in the direction of the visible lines.
Model compatibility
- DTDL wall panels are not suitable for high-humidity environments.
Manual page author
Michael Turner
Technical manual editor
Reviews PDF manuals for structure, safety notes, and practical product details so readers can find the right information quickly.