Automotive / Lighting Accessories
User Manual for Strands Siberia NG 20-Inch Warning Light LED Bar
Quick guide for the Strands Siberia NG 20-Inch Warning Light LED Bar. Includes wiring instructions, installation tips, maintenance advice, and safety warnings.
Quick answers from the manual
Quick answer
- The Strands Siberia NG 20-Inch Warning Light LED Bar requires specific wiring for different light functions and has strict installation guidelines regarding cable length and connector integrity to maintain the warranty. p. 1
Key actions
- Connect Red to positive, Black to chassis ground, Yellow to amber position light, Grey to white position light, and Green to amber warning light. p. 1
- Do not cut the connector or shorten cables below 50 cm. p. 1
Maintenance and reset
- Clean with lukewarm water and alkaline degreasing. Rinse gently with low pressure. p. 1
Show 1 more answers Show less
Where to find it in the PDF
- Installation and Wiring p. 1
Table of contents
Important Information
This guide provides essential instructions for the installation and maintenance of the Strands Siberia NG 20-Inch Warning Light LED Bar. Always study the diagrams and instructions before beginning installation to ensure proper usage and to maintain your warranty.
Wiring Instructions
Connect the wires according to the following color code:
- Red: Positive (+)
- Black: Chassis Ground (-)
- Yellow: Amber Position Light
- Grey: White Position Light
- Green: Amber Warning Light
Installation Guidelines
Follow these rules to ensure a correct installation and to keep your warranty valid:
- Connectors: If the product has a contact or connector, do not cut it. Cutting the connector voids the warranty.
- Cable Length: If the cable is shorter than 50 cm, do not cut it. If the cable is longer than 50 cm, you may shorten it, but not to a length shorter than 50 cm.
- Mounting: Tighten screws and bolts securely so they do not loosen or chafe, but be careful not to over-tighten, as this may break the protective bearings.
- Legal: Check with state or local authorities regarding laws governing the usage and mounting of your new lights.
Maintenance and Care
To prolong the product's lifetime, keep the lens and heat-sink clean.
- Use lukewarm water and alkaline degreasing for cleaning.
- Follow degreasing instructions carefully.
- Rinse off gently with cold or lukewarm water using low pressure.
- Warning: Do not use strong chemicals, as they may dissolve sealing adhesives, compromise waterproofness, or make plastic/rubber components brittle.
- Warning: Do not use high-pressure water close to the product.
Safety Warnings
- Do not use higher voltage than specified in the product description.
- The light becomes hot during continuous use. Do not touch or remove the casing for at least 30 minutes after turning the lamp off.
Practical help
Common problems
Cable is too long
You may shorten the cable, but do not cut it shorter than 50 cm to maintain the warranty.
Connector is in the way
Do not cut the connector. Cutting the connector voids the warranty.
Before use
- Verify the power supply voltage matches the product description.
- Ensure all wiring connections are correct according to the color code.
- Check that screws and bolts are tightened securely without over-tightening.
- Ensure the lens and heat-sink are clean.
Show more Show less
Images and diagrams
- The diagram provides the physical dimensions of the light bar in millimeters to assist with mounting.
Model compatibility
- Ensure the power supply voltage does not exceed the product specifications.
Manual page author
Emily Carter
User documentation editor