Installation Manual for Sunco Lighting UFO High Bay LED Fixture

Quick Installation Guide

This document provides instructions for installing the Sunco Lighting UFO High Bay LED Fixture. Ensure power is turned off at the circuit breaker before beginning any installation work. The installation requires a drill, ladder, screwdriver, safety cables, and wire nuts.

Components

• 1x Lifting Hook

Installation Steps

1. Turn off power at the circuit breaker.
2. Drill a pilot hole in the ceiling and install a chain or ceiling hook (not included) for adequate support.
3. Attach the provided lifting hook by turning it clockwise into the UFO fixture. Tighten the screw to lock it in place.
4. Hang the fixture onto the ceiling using the lifting hook.
5. Secure the light with safety cables (not included) to prevent it from falling. Use the screw to lock the lifting hook in place.
6. Connect supply wires to fixture wires using wire nuts: Black to Black, White to White, and Ground to Ground.
7. Turn on the circuit breaker and test the light.

Safety Warnings

• This product should be installed by a person familiar with the construction and operation of the product.
• Always turn off power to the switch and circuit breaker before installing.
• Proper grounding is required for safety.
• Do not install this fixture in the rain.
• If you experience smoke or fire in the wires or lamps, turn off the power immediately and notify relevant personnel.
• Clean the fixture regularly; do not use harsh solvents.
• Safety eyeglasses and gloves are recommended.

Specifications

• Voltage: 100-277V
• Wattage: 150W
• Moisture Rating: Wet
• Housing Material: Aluminum Alloy + PC
• Weight: 6.2 lbs
• Warranty: 12 Years