Lighting / Fixtures
Tecnolite 10SOLLED32VCD65N Gomea Outdoor Solar LED Wall Lamp
Instruction manual for the Tecnolite Gomea solar-powered outdoor LED wall lamp, covering installation, operation modes, and maintenance.
Table of contents
Product Overview
The Tecnolite 10SOLLED32VCD65N Gomea is an outdoor solar-powered LED wall lamp designed for exterior illumination. It features an integrated solar panel, motion sensor, and a rechargeable lithium battery. The unit is rated IP65 for weather resistance and IK06 for impact protection, making it suitable for outdoor environments.
Installation and Setup
Before the first use, the lamp must be charged completely for 24 hours under direct sunlight. The recommended mounting height is 4 meters to ensure optimal motion sensor coverage. The package includes necessary mounting hardware (screws and anchors). Ensure the unit is installed at least 0.50 meters away from any combustible materials to prevent fire hazards.
Operation Modes
The lamp features a power button to cycle through three distinct operation modes:
- Mode 1: Light is off at night. It turns on at 100% brightness when motion is detected and dims after 20 seconds of no motion.
- Mode 2: Light stays on at 30% brightness at night. It turns on at 100% brightness when motion is detected and returns to 30% after 20 seconds of no motion.
- Mode 3: Light stays on continuously at a set brightness.
Pressing the button again will deactivate the unit.
Maintenance and Safety
To maintain the efficiency of the solar panel and the light output, clean the unit periodically with a dry cloth. Do not use harsh chemicals or abrasive materials. Ensure the lamp is disconnected from any power source during installation or maintenance. This appliance is not intended for use by individuals with reduced physical, sensory, or mental capabilities unless supervised by a responsible person. Keep out of reach of children.
Contact Information
For technical support or warranty inquiries, contact Tecnolite Mexico at their Poniente Industrial Park location or via their official website at www.tecnolite.mx.
Official resources from the manual
Manufacturer information
Tecnolite
Practical help
Common problems
Lamp does not turn on after installation
Ensure the unit was charged for a full 24 hours in direct sunlight before the first use.
Motion sensor not triggering
Verify the mounting height is approximately 4 meters and that there are no obstructions blocking the sensor.
Before use
- Charge the unit for 24 hours in direct sunlight before first use.
- Ensure the mounting location is at least 0.50m away from combustible materials.
- Verify the mounting height is approximately 4 meters.
- Check that all included screws and anchors are used for secure mounting.
Images and diagrams
- The installation diagram shows two mounting options: Option 1 using a single bracket and Option 2 using a dual-bracket configuration.
- The operation diagram illustrates the solar panel orientation and the location of the power button and motion sensor.
Model compatibility
- Designed for outdoor use only.
- Not intended for use by children or persons with reduced capabilities without supervision.
Manual page author
Emily Carter
User documentation editor
Prepares concise manual descriptions and highlights the most useful setup, operation, and maintenance information for readers.