Timex 04K-096000 LCD Analog Watch User Manual

Quick Start Guide

Safety Warning: This product contains a button cell or coin battery. Ingestion can cause severe internal chemical burns and death in as little as 2 hours. Keep new and used batteries out of reach of children. If a battery is swallowed, seek immediate medical attention.

Battery Replacement: The battery is not intended to be replaced by the consumer. Only a jeweler or professional should replace the battery.

Features and Basic Operations

The watch features an LCD analog (hands) and digital display with hours, minutes, and seconds. It includes a daily alarm, hourly chime, 24-hour stopwatch with split time, 60-minute countdown timer, and dual time zone capability.

Time and Date Setting

1. Press MODE repeatedly until the time is shown with the seconds flashing.
2. Press LAP/RESET to set seconds to zero.
3. Press START/STOP to select minutes, then LAP/RESET to advance. Press and hold to increment quickly.
4. Press START/STOP to select hours, then LAP/RESET to advance to AM or PM.
5. Press START/STOP to select date (01-31), then LAP/RESET to advance.
6. Press START/STOP to select month (01-12), then LAP/RESET to advance.
7. Press START/STOP to select day (SUN-SAT), then LAP/RESET to advance.
8. Press MODE to exit time set.
9. To switch between AM/PM and 24-hour format, press and hold START/STOP for 4 seconds.

Dual Time

1. Press MODE until the indicator is next to DUAL T.
2. Press START/STOP. The hour hand will flash.
3. Press LAP/RESET to advance the hour hand.
4. Press START/STOP. The minute hand will flash.
5. Press LAP/RESET to advance the minute hand.
6. Press START/STOP to exit.

Alarm

1. Press MODE until the indicator is next to ALARM.
2. Press START/STOP and LAP/RESET simultaneously to enable/disable the alarm or chime.
3. To set the alarm time, press MODE to ALARM, then START/STOP to select the hour hand.
4. Use LAP/RESET to adjust the hour, then press START/STOP to select the minute hand.
5. Use LAP/RESET to adjust the minutes, then press START/STOP to exit.

Timer

1. Press MODE until the indicator is next to TIMER.
2. Press LAP/RESET repeatedly to increase the number of minutes.
3. Press START/STOP to begin the countdown.
4. Press START/STOP to pause or resume.
5. Press LAP/RESET to reset the timer.

Stopwatch

1. Press MODE until the indicator is next to STOP.
2. Press START/STOP to start the stopwatch.
3. Press LAP/RESET to record a split time.
4. Press START/STOP to pause.
5. Press LAP/RESET to reset to zero.

Display Light

Press the LIGHT button to activate the display light.

Bracelet Adjustment

1. Open the locking plate.
2. Move the clasp to the desired bracelet length.
3. Exert pressure while holding the locking plate and slide the clasp back and forth until it engages in the grooves on the underside of the bracelet.
4. Press the locking plate down until it snaps closed.

Water Resistance and Maintenance

This watch is water-resistant to 30 meters. To maintain water resistance, do not press any buttons while underwater. Rinse the watch with fresh water after exposure to salt water. The watch is not a diver watch and should not be used for diving.