Garden / Pool Equipment
Installation Guide for Vevor 16X32FT Mesh Safety Pool Cover
Complete installation guide for the Vevor Mesh Safety Pool Cover. Includes step-by-step instructions for drilling, setting anchors, attaching springs, and removing the cover.
Quick answers from the manual
Quick answer
- To install the Vevor Mesh Safety Pool Cover, drill 1-5/8" deep holes using a 3/4" masonry bit, insert the anchors flush with the deck, adjust them with a hex key, and secure the cover by looping the straps through the springs and leveraging them onto the anchors. p. 1
Key actions
- Drill anchor holes p. 1
- Attach springs p. 1
Problems and fixes
Too much tension on spring
Loosen the strap and repeat the fastening procedure.
p. 1Maintenance and reset
- Removing the cover p. 1
Technical specifications
| Parameter | Value | Meaning | Pages |
|---|---|---|---|
| Drill depth | 1-5/8 inches | Required depth for anchor installation | p. 1 |
| Masonry bit | 3/4 inch | Required bit size for drilling | p. 1 |
Where to find it in the PDF
- Installation Instructions p. 1
Table of contents
Manual images
Click an image to enlargeQuick guide from the manual
This guide covers the installation of the Vevor Mesh Safety Pool Cover. The process involves drilling holes for anchors, setting the anchors, and securing the cover using straps and springs.
Warning: Always wear goggles or other appropriate eye protection when using power tools to install anchors.
Setting the anchors
To install the anchors into the pool deck:
- Drill a hole approximately 1-5/8 inches deep into the deck using a rotary hammer drill with a 3/4 inch masonry bit.
- Vacuum or flush out all concrete dust from the bottom of the hole.
- Insert the anchor into the hole and hammer it until it is flush with the pool deck.
- Adjust the insert up to 1/2 inch using a hex key.
Attaching the springs
Follow these steps to secure the cover to the anchors:
- Step 1: Pass the strap under the front of the spring and through the middle of the square ring.
- Step 2: Loop the strap over the top of the square ring and back under the front of the spring, then pull tight.
- Step 3: Slide the spring onto the end of the rod until it is approximately 6 inches from the end. Leverage the rod onto the insert and push the spring down into position using your shoe (never use your hand). Pull the rod out once the spring is in place.
If there is too much tension on the spring, loosen the strap and repeat the fastening procedure.
Removing the cover
To remove the pool cover, rotate the tension bar to disassemble the springs from the anchors.
Manufacturer information
VEVOR
Practical help
Common problems
Too much tension on the spring during installation
Loosen the strap and follow the fastening procedures again.
Debris in the anchor hole
Vacuum or flush out the concrete dust from the bottom of the hole before inserting the anchor.
Before use
- Wear goggles or appropriate eye protection
- Rotary hammer drill
- 3/4 inch masonry bit
- Vacuum or water source for cleaning holes
Specs in practice
- Masonry bit size
- 3/4 inch
- Insert adjustment
- Up to 1/2 inch using hex key
Images and diagrams
- The manual provides visual steps for drilling the anchor hole, inserting the anchor, and the three-step process for attaching the spring to the strap and anchor.
- A specific diagram illustrates how to use the tension bar to remove the cover.
Manual page author
Emily Carter
User documentation editor
Prepares concise manual descriptions and highlights the most useful setup, operation, and maintenance information for readers.