User Manual for CLAS Air Reel OP 1118 and OP 1119

Quick Guide

The CLAS Air Reel (OP 1118/OP 1119) is designed for air distribution. It must be installed horizontally on a wall or post, ideally 1 meter above the ground. Do not use this device for drinking water, chemicals, grease, or toxic substances.

Introduction and Safety

The device is maintenance-free regarding internal cleaning. Do not clean the interior with water. Always hold the hose stop ball when the hose is retracting to prevent damage or injury.

Parts List

• Hose reel (1)
• Mounting bracket (1)
• Plastic dowel (5)
• Self-tapping screws (1)
• 4*12 (1)

Installation

1. Remove the unit and accessories from the box.

2. Choose a suitable location near an air source.

3. Use the mounting bracket as a template to mark the screw positions.

4. Drill four holes (12mm x 60mm) into the wall.

5. Fix the bracket using the four self-tapping screws.

6. Connect the reel to the mounting bracket.

Operation

Unwinding: Pull the hose to the desired length and stop at any point.

Retracting: Pull slightly on the hose and guide it as it winds back into the housing.

Storage and Maintenance

When not in use, turn off the air source and purge the reel. If storing for an extended period, keep it in a cool, dry place.

Troubleshooting

If the hose does not retract, it may be because the hoses are stacked on top of each other. Pull out the entire hose and let it retract slowly while holding it. If the spring has no return, contact customer service immediately due to the risk of injury.

Contact

For components, parts, or technical issues, contact your reseller or authorized technician. CLAS Equipements, 83 chemin de la CROUZA, 73800 CHIGNIN, FRANCE. Phone: +33 (0)4 79 72 62 22. Fax: +33 (0)4 79 72 52 86.