Crystorama 130-MK Calypso Three Light Mini Chandelier Instruction Manual

Quick guide from the manual

This document provides installation instructions for the Crystorama 130-MK Calypso chandelier. The fixture is damp-rated and requires installation by a licensed electrician in accordance with local electrical codes. Ensure power is turned off before starting any work.

Safety and Requirements

• Electrical Safety: All electrical components must be installed by a licensed electrician.
• Bulb Requirements: Uses 3 Candelabra Base bulbs. 40 Watts recommended, 60 Watts maximum. LED bulbs are recommended for extended use.
• Damp Rated: Suitable for damp locations.

Installation for Hanging

1. Determine the desired hanging height and adjust the chain accordingly.
2. Open one link of the chain, connect it to the fixture loop, and close the link. Repeat for the canopy loop.
3. Thread the mounting screws into the mounting bar and secure with the small hex nut.
4. Attach the mounting bar to the outlet box using the provided screws.
5. Raise the canopy, allowing the mounting screws to protrude through the holes, and secure with the ball nut.
6. Hang crystals on the metal ring and bottom basket, alternating between glass drops A and B.
7. Attach glass drop C to the bottom of the bottom basket.
8. Install the bulbs into the sockets.

Installation for Ceiling Mount

1. Loosen the hex nut of the canopy and disassemble.
2. Remove the loop from the top of the fixture.
3. Slide the canopy, metal washer, and lock washer over the nipple, then secure with the hex nut.
4. Thread the mounting screws into the mounting bar and secure with the small hex nut.
5. Attach the mounting bar to the outlet box using the provided screws.
6. Raise the canopy, allowing the mounting screws to protrude through the holes, and secure with the ball nut.
7. Install the bulbs into the sockets.
8. Hang crystals on the metal ring and bottom basket, alternating between glass drops A and B.
9. Attach glass drop C to the bottom of the bottom basket.

Crystal Assembly

The fixture requires specific crystal placement to achieve the correct look. Hang crystals on the metal rings and bottom basket by alternating between glass drop A (30mm) and glass drop B (76mm). Finally, attach the single glass drop C (30mm ball with chain) to the very bottom of the basket.