Lighting / Fixtures
Crystorama 1486-HB-CL-MWP Majestic 11 Light Chandelier Instruction Manual
Quick guide for the Crystorama 1486-HB-CL-MWP Majestic 11-light chandelier. Includes installation steps, crystal dressing instructions, component list, and electrical safety requirements.
Table of contents
Quick guide from the manual
This document provides assembly and installation instructions for the Crystorama 1486-HB-CL-MWP Majestic chandelier. The fixture is dry-rated and requires installation by a licensed electrician in accordance with local and national electrical codes. Ensure power is turned off at the circuit breaker before beginning any work.
Installation and Assembly
- Perform a complete inventory of all parts and components listed in the manual before starting.
- Securely attach the mounting bar and fixture to the outlet box.
- Install the bobeches and bulbs.
- Connect the power supply.
- Dress the fixture with crystals, starting with the pocket labeled (A) and applying all crystal sets in alphabetical order (A through E).
Crystal Dressing Guide
The chandelier requires precise placement of crystal sets:
- Set A: 224 sets (14mm + AS2-1.5")
- Set B: 15 sets (14mm + AS20-3")
- Set C: 25 sets (27x 14mm)
- Set D: 50 sets (28mm + 26mm + 24mm + 20mm + 18mm + 16mm)
- Set E: 1 piece (5x 14mm + AS8-40mm Ball)
Technical Specifications
- Bulb Requirements: 13 Candelabra base bulbs.
- Wattage: 40W recommended, 60W maximum per bulb. LED bulbs are recommended for extended use.
- Rating: Dry rated.
Safety Warnings
This product contains lead, which is known to the State of California to cause cancer and/or birth defects or reproductive harm. For more information, visit www.P65warnings.ca.gov.
Official resources from the manual
Manufacturer information
Crystorama
Practical help
Common problems
Fixture not lighting up
Ensure the power is on at the breaker and all bulbs are properly seated in the sockets.
Crystal placement confusion
Follow the alphabetical order (A-E) as specified in the manual and verify the pin hole counts on the banding kits.
Before use
- Verify all parts against the provided part number list.
- Ensure the outlet box is capable of supporting the fixture weight.
- Confirm power is disconnected at the source.
- Check that you have 13 Candelabra base bulbs.
- Ensure a licensed electrician is available for installation.
Specs in practice
- Candelabra Base
- Standard E12 base bulbs required for this fixture.
Model compatibility
- Use LED bulbs for extended life and energy efficiency.
- Do not exceed 60W per bulb.
Manual page author
Emily Carter
User documentation editor
Prepares concise manual descriptions and highlights the most useful setup, operation, and maintenance information for readers.