Lighting / Controllers & Dimmers
Installation and Operation Guide for Enerlites 17027-F3 3-Speed Fan Control and LED Dimmer
Quick guide for the Enerlites 17027-F3 3-speed fan control and LED dimmer. Includes wiring instructions, installation warnings, operating tips, and technical specifications.
Quick answers from the manual
Quick answer
- The Enerlites 17027-F3 is a single-pole wall switch that combines 3-speed fan control and light dimming. It requires no neutral wire and is designed for 120VAC systems. p. 1
Key actions
- Connect HOT wire to HOT terminal, FAN wire to LOAD terminal, LIGHT wire to LIGHT LOAD terminal, and GROUND wire to GROUND terminal. p. 1
First start
- Set the ceiling fan speed to high using the pull string before using the wall control. p. 1
Technical specifications
| Parameter | Value | Meaning | Pages |
|---|---|---|---|
| Voltage | 120VAC, 60Hz | Operating voltage | p. 1 |
| Fan Load | 2.5A | Max fan current | p. 1 |
| Incandescent/Halogen Load | 360W | Max wattage | p. 1 |
Where to find it in the PDF
- Installation and Wiring p. 1
Table of contents
Quick guide from the manual
The Enerlites 17027-F3 is a single-pole wall switch designed to control both ceiling fan speed and light brightness from a single unit. It features three fan speeds and a dimming slider. This device does not require a neutral wire for installation.
Safety warnings
- Turn off the power at the circuit breaker before beginning any installation.
- Installation should be performed by a qualified electrician in accordance with the National Electric Code and local regulations.
- Do not use this device to control receptacles, motor-operated appliances, fluorescent lighting fixtures, or transformer-supplied appliances.
- Risk of electric shock: More than one disconnect switch may be required to de-energize the device before servicing.
- Use copper wire only.
Installation instructions
Ensure power is disconnected before wiring. Follow these steps to connect the switch:
- Insert the HOT wire to the fan's HOT terminal.
- Insert the FAN wire to the fan's LOAD terminal.
- Insert the LIGHT wire to the fan's LIGHT LOAD terminal.
- Insert the GROUND wire to the fan's GROUND terminal.
Operating instructions
Before using the switch to control your fan, you must first set the speed on the ceiling fan itself to high using the pull string (if equipped). The dimming slider has an off position at the bottom; you will feel a click when you slide it to turn the lights off. Ensure you are using dimmable light bulbs with this device.
Technical specifications
- Voltage: 120VAC, 60Hz
- Fan Load: 2.5A
- Incandescent/Halogen Load: 360W
- LED/CFL Load: 200W
- Operating Temperature: 32°F - 104°F
Practical help
Common problems
Light flickering or not dimming correctly
Ensure that the light bulbs installed in the fixture are dimmable.
Fan speed control not working
Ensure the ceiling fan is set to the high speed setting using the fan's pull string before using the wall control.
Before use
- Turn off power at the circuit breaker
- Verify the installation is for a single pole setup
- Ensure light bulbs are compatible (dimmable)
- Set ceiling fan to high speed via pull string
- Use copper wire only
Specs in practice
- Incandescent/Halogen
- Maximum wattage for these bulb types is 360W.
Model compatibility
- Not for use with receptacles
- Not for use with motor-operated appliances
- Not for use with fluorescent lighting fixtures
- Not for use with transformer supplied appliances
Manual page author
Emily Carter
User documentation editor
Prepares concise manual descriptions and highlights the most useful setup, operation, and maintenance information for readers.