Lighting / Fixtures
Hinkley 24020BK/24024 Wall Mount Light Installation Manual
Installation guide for Hinkley 24020BK and 24024 wall mount lights. Includes step-by-step mounting, wiring, glass installation, and weatherproofing instructions.
Quick answers from the manual
Quick answer
- This manual provides installation instructions for Hinkley 24020BK and 24024 wall mount lights, including mounting, wiring, glass installation, and weatherproofing. p. 1, 2, 3, 4
Key actions
- Mounting the fixture p. 1
- Installing glass panels p. 2
- Wiring and grounding p. 3
- Caulking for weather protection p. 4
Where to find it in the PDF
- Assembly Instructions p. 1
- Glass Installation p. 2
- Wiring and Grounding p. 3
- Caulking Instructions p. 4
Table of contents
Manual images
Click an image to enlargeQuick guide from the manual
This document provides installation instructions for Hinkley models 24020 and 24024. Always turn off the power supply before beginning any installation work. If you are unfamiliar with electrical wiring, consult a qualified electrician.
Assembly and Mounting
To install the fixture:
- Remove the mounting plate (A) from the body of the fixture by unscrewing the four screws on the side of the outer body.
- Attach the mounting plate (A) to the junction box (J) using the provided screws.
- Make all necessary wiring connections as described in the wiring section.
- Align the outer body with the mounting plate and secure it using the four screws removed in step 1.
Glass Installation
It is recommended to install the glass panels before mounting the fixture to the wall.
- Slide the glass panels (2) into the outer body from the back.
- Ensure the bottom of the glass panel is seated in the channel (3) at the bottom of the outer body.
- Tip the glass up into position.
- Bend the clips (4) over the glass to secure it in place.
Wiring and Grounding
Follow these steps for electrical connections:
- Positive Wire: Connect the supply wire (typically black or smooth side) to the positive fixture lead (B) using a twist-on connector.
- Negative Wire: Connect the supply wire (typically white or ribbed side) to the negative fixture lead (D) using a twist-on connector.
- Grounding: Fasten the fixture ground wire (E) to the mounting strap (M) using the ground screw (S).
Weatherproofing
To prevent water from entering the junction box, it is recommended to seal the fixture:
- Use a good quality waterproof caulk or silicone sealant to seal the gap between the fixture backplate and the wall on the top and both sides.
- Apply a small bead of caulk under the ball knobs used to mount the fixture.
Manufacturer information
Hinkley Lighting
Practical help
Common problems
Water entering junction box
Use waterproof caulk to seal gaps between the fixture backplate and the wall on the top and both sides.
Glass loose
Ensure glass panels are fully seated in the channel and bend the clips (4) to secure them.
Before use
- Turn off power supply
- Verify junction box is compatible
- Have waterproof caulk/silicone sealant ready
- Ensure all wiring connections are secure
Show more Show less
Specs in practice
- Positive wire
- Typically black or smooth side of the two-conductor cord
- Negative wire
- Typically white or ribbed side of the two-conductor cord
Images and diagrams
- Drawing 1: Mounting fixture to junction box
- Drawing 1 (Glass): Installing glass panels into outer body
- Drawing 1 (Wiring): Flush mount wiring diagram
Model compatibility
- Suitable for indoor and outdoor use
- Requires standard junction box
Manual page author
Emily Carter
User documentation editor