Installation Instructions for Mayfair Seaside Bay Path Bollard

Important Information

This document provides installation instructions for the Mayfair Seaside Bay Path Bollard (SKU# 220418, 229400). Please note the following critical requirements:

• Voltage: This luminaire is rated for 12V AC/DC (Extra Low Voltage) only. Do not plug it directly into 240V mains.
• Components: The Lucci wiring kit and Lucci transformer are required for installation and are sold separately.
• Compatibility: This product is not suitable for use with dimmer switches.
• DIY: This luminaire is classified as DIY and does not require electrical connection or disconnection by a licensed electrician, provided you are working on the 12V side only.

Installation Requirements

Before beginning the installation, ensure you meet the following criteria:

• Wiring Rules: All installation must adhere to local and national wiring rules (e.g., AS/NZS 3000).
• Location: The luminaire is IP65 rated, meaning it is protected against low-pressure water jets. Ensure the location allows for proper water drainage.
• Substrate: The mounting point must support at least twice the weight of the luminaire.
• Protection: Do not use the luminaire if the protective shield is cracked.
• Drainage: Ensure the quick connector and wiring kit are not installed in areas where they will be submerged in water or buried without protection.

Installation Directions

1. Ensure the power to the circuit is switched OFF before starting any work.
2. Remove all packaging material from the luminaire (A), ensuring no accessories are discarded.
3. Select a suitable location with adequate space for the luminaire and wiring.
4. Use the quick connector (B) to connect the luminaire to the Lucci wiring kit. Ensure the connector is fully tightened.
5. Connect the Lucci wiring kit to the Lucci transformer. Do not exceed the load ratings of the wiring kit (Max 80VA) and transformer.
6. Apply a non-corrosive bead of silicon before installation onto the wall or surface to prevent water from running into the cabling.
7. Insert the transformer plug into the mains power socket and switch on the luminaire to test.

Safety Tips

• Always ensure the power is OFF and the luminaire has cooled down before maintenance or cleaning.
• The external flexible cable cannot be replaced; if damaged, the entire luminaire must be destroyed.
• The light source is not replaceable. When it reaches the end of its life, the whole luminaire must be replaced.
• Do not attempt to dismantle or open the luminaire.
• Clean only with a soft damp cloth. Do not soak or immerse in water or other liquids.
• Avoid contact with corrosive chemicals, solvents, or abrasive cleaners.

Specifications

• SKU Numbers: 220418 (Aged Solid Bronze), 229400 (Solid Brass)
• Rated Voltage: 12V AC/DC
• Rated Wattage: 8W
• LED Specs: 300 lumens, Warm-White (3000K), CRI > 80, Non-Dimmable
• IP Rating: IP65
• Weight: 1.1kg
• Dimensions: H: 725mm, W: 65mm, L: 160mm