User Manual for Sealey VS7019 10L Pneumatic Transmission Oil Filling System

Quick guide from the manual

The Sealey VS7019 is a pneumatic oil dispensing unit with a 10L capacity. It is designed for filling transmission fluid and includes a range of eight adaptors. Always wear eye protection and protective clothing during operation. Ensure the unit is not used for corrosive fluids and never exceed the maximum pressure of 100psi (7bar).

Safety

• Always wear safety eye protection and protective clothing.
• Ensure the work area is clean, uncluttered, and well-lit.
• Maintain correct balance and footing; wear non-slip shoes.
• Keep children and unauthorized persons away from the working area.
• DO NOT use to extract corrosive fluids.
• DO NOT dismantle, tamper with, or adapt the pump for any purpose other than its design.
• DO NOT use the unit if it has been dropped or mishandled.
• Always pay attention to the pressure control as this is a pressurized unit.

Introduction and Specifications

This pneumatic operated oil dispensing unit features a large visual measurement container to identify the amount dispensed and a safety valve to prevent over-pressurizing. It comes with a storage case for adaptors to minimize oil leakage.

• Model No: VS7019
• Capacity: 10L
• Maximum Pressure: 100psi (7bar)
• Nett Weight: 3.02kg

Contents

The unit is supplied with eight transmission fluid adaptors:

• VS7009.A05: Adaptor VW Audi
• VS7009.A04: Adaptor VW Audi
• VS7009.A03: Adaptor VW Audi
• VS7009.A02: Adaptor universal
• VS7009.A01: Adaptor Ford
• VS70090.02: Audi/VW CVT
• VS70090.03: Audi/VW DSG
• VS70090.01: Mercedes

Operation

Filling New Fluid

1. Open the filling cap and fill with oil to the desired level. DO NOT overfill beyond the 10L capacity.
2. To fill the tank by vacuum: Ensure the vacuum function switch is in the vacuum position (see fig.1).
3. Insert the dispensing hose into the oil container.
4. Select the appropriate adaptor for the vehicle and connect it to the dispensing hose.
5. Connect compressed air to the air inlet on the handle and press the trigger to create the vacuum required to draw new oil into the tank.

Filling Transmission Fluid

1. Select the appropriate adaptor from the box for the specific vehicle.
2. Connect the adaptor to the dispensing hose.
3. Unscrew the fitting from the end of the dispensing valve assembly (see fig.2).
4. Insert the required adaptor and slide the dispensing valve nut (and seal) over the adaptor and tighten.
5. Turn the valve on the handle to the ON position to dispense oil into the transmission.
6. Turn the valve to the OFF position to stop the flow.

Maintenance

Wipe the unit down after use. DO NOT use solvents for cleaning.