User Manual for Sealey 10L Dehumidifier SDH102.V2

Quick guide from the manual

The Sealey 10L Dehumidifier (SDH102.V2) is designed to remove excess moisture from the air. Before use, ensure the unit is placed on a level, stable surface with at least 30cm of clearance from the front, rear, and sides, and 50cm above. Keep all doors and windows closed during operation. Important: This unit contains R290 refrigerant gas and must be installed and stored in a room with a floor area larger than 4m².

Operation

The unit features a digital control panel with an LED display.

• Power: Press the power button to start. The unit defaults to 60% RH, automatic mode, and high-speed operation.
• Mode: Switch between modes using the mode button.
  • Auto Mode: The unit adjusts based on set humidity. Fan speed and humidity can be adjusted.
  • Continuous Drying Mode: The unit runs continuously; humidity cannot be adjusted.
  • Sleep Mode: Indicators fade after 10 seconds, and fan speed switches to low.
• Humidity Setting: In auto or sleep mode, press the button to adjust humidity in 5% increments (30%-80%). Hold the button to display ambient temperature.
• Timer: Set from 0-24 hours in 1-hour increments. Set to 00 to cancel.
• Fan Speed: Adjustable only in automatic mode (high/low).
• Lock: Engages the child lock function, disabling other keys.

Drainage

When the water tank is full, the warning light flashes, and the unit stops. To empty, remove the lower rear cover by pulling from both sides, then slide the tank out. For continuous drainage, connect a water pipe (not supplied) with an inner diameter of 9mm to the rear drain. Ensure the pipe is not longer than 1.5m and remains lower than the outlet height throughout its length.

Maintenance

Switch off and unplug the unit before maintenance.

• Filter Cleaning: Clean the air filter every two weeks. Remove the water tank, pull down the filter tab, and wash with water only. Do not use hot water, solvents, or heat to dry. Snap back into place once dry.
• Casing Cleaning: Wipe with a damp cloth. Do not use detergents or abrasive cleaners.

Troubleshooting

If the unit does not operate, check the power supply, ensure the water tank is not full, and verify the tank is fitted correctly. If dehumidified volume is low, check for a dirty filter or obstructions at the air inlets/outlets. The unit will not operate below 5°C. Error codes include E2 (humidity sensor problem), LO (humidity below 20%), HI (humidity above 90%), CL (low-temperature protection), and CH (high-temperature protection).