User Manual for SIIG 04-1054B Serial/Parallel Port PCIe Card

Quick guide from the manual

This document provides essential setup information for the SIIG Serial/Parallel Port PCIe card. Before installation, ensure your computer has an available PCIe slot and is running a compatible operating system. The card is designed for plug-and-play functionality in many systems, but manual driver installation may be required if the system does not automatically detect the device.

System Requirements

To ensure proper operation, your computer must meet the following requirements:

• Hardware: An available PCIe slot.
• Windows: Windows 11, 10, 8.1, or 7 (32/64-bit).
• Windows Server: Windows Server 2019, 2016, 2012 R2, 2012, 2008 R2, 2008, or 2003 (32/64-bit).
• Linux: Linux kernel 2.6 and later versions.

Features

• Bus connector: PCI Express x1.
• Compliance: PCI Express 1.1.
• Serial Port Baud rate: Up to 115.2 Kbps.
• Serial Port FIFO: 256 Bytes.
• Serial Port UART: 16C550.

Driver Installation

Follow these steps to install the necessary drivers:

1. Check if your system has a built-in driver that can use the card directly. If it works, no further installation is necessary.
2. If the card is not recognized, visit the official SIIG website.
3. Use the specific product number (e.g., LB-xxxxxx-S1) to locate and download the correct driver.
4. Run the Setup.exe file to install the driver.
5. Follow the on-screen installation prompts to complete the process.

Support

For additional information or technical support, please visit the official support page at http://www.siig.com/support.