Lighting / Controllers & Dimmers
User Manual for Sunricher INGY 0-10V Fixture-integrated Sensor-less Controller SR-IG9032A-V
Quick guide for the Sunricher INGY 0-10V Fixture-integrated Sensor-less Controller (SR-IG9032A-V). Learn about wiring, installation, reset procedures, and technical specifications.
Table of contents
Manual images
Click an image to enlargeQuick guide from the manual
The Sunricher INGY 0-10V Fixture-integrated Sensor-less Controller (SR-IG9032A-V) is a device designed to convert signals for 0-10V lighting systems using a Wirepas mesh network. Key operational requirements include a 12-24VDC power supply and correct wiring to the 0-10V dimmable driver. The device supports magnetic reset and is compatible with kinetic energy switches and EnOcean switches (EWSSB and EWSDB).
Product Overview
This controller acts as a signal converter and mesh network node. It features an on-board antenna and is rated IP20 for indoor use. It allows for broadcast control of all devices on the 0-10V line.
Wiring and Installation
Warning: Do not install the device while power is applied. Ensure all connections are made according to the provided wiring diagram.
- V+: Connect to the positive terminal of the 12-24VDC power supply.
- GND: Connect to the common port for V- and Dim-.
- DIM+: Connect to the 0-10V signal port of the dimmable driver.
The device should be installed in an environment with a temperature range of 0°C to 45°C and relative humidity between 8% and 80%.
Operation
To reset the device, press and hold the "Reset" button on the controller for over 5 seconds. The indicator LED will flash to confirm that the device has been successfully reset and withdrawn from the internet/APP.
Technical Specifications
- Input Power: 12-24VDC
- Signal: Wirepas (INGY)
- Output Current: Max 20mA
- Dimming Curve: Logarithmic
- Dimming Method: PWM
- Operating Temperature: 0°C to 45°C
- Waterproof Grade: IP20
Practical help
Common problems
Device not responding or not connecting
Ensure the device is powered with 12-24VDC and wiring is correct. Perform a reset by holding the button for 5 seconds.
Need to remove device from network/APP
Press and hold the Reset button on the controller for over 5 seconds until the LED flashes.
Before use
- Verify power supply is 12-24VDC.
- Ensure installation environment is between 0°C and 45°C.
- Confirm wiring matches the connection diagram (V+, GND, DIM+).
- Ensure power is disconnected before installation.
- Check compatibility with your switch type (Kinetic or EnOcean).
Specs in practice
- Output Current
- Maximum 20mA for the 0-10V signal.
- Dimming Method
- Uses PWM (Pulse Width Modulation) for dimming.
Images and diagrams
- The wiring diagram illustrates the connection between the 12/24V PSU, the controller, and the 0-10V Dimmable Driver.
- The dimension drawing provides the physical size of the controller for installation planning.
Model compatibility
- Compatible with kinetic energy switches.
- Compatible with EnOcean switches EWSSB and EWSDB.
Manual page author
David Miller
Documentation analyst
Organizes user manual content into clear summaries, with attention to model details, product context, and everyday usability.