Lighting / Controllers & Dimmers
User Manual for Aurora 12V Constant Voltage 16W LED Driver
Quick guide for the Aurora 12V Constant Voltage 16W LED Driver. Includes installation instructions, wiring diagrams for parallel connections, safety warnings, and technical specifications for models AU-LED16IP and AU-LED16T.
Table of contents
Manual images
Click an image to enlargeQuick guide from the manual
This document provides installation and safety instructions for the Aurora 12V Constant Voltage 16W LED Driver. The primary requirement for operation is that all Constant Voltage LED lamps must be wired in parallel. Ensure the total wattage of connected lamps does not exceed 16W. Always isolate the mains supply before performing any installation or maintenance.
Installation
Installation must be carried out in accordance with the latest edition of the National Wiring Regulations. If you are in doubt, consult a qualified electrician.
- AU-LED16IP: This model is IP68 rated, providing protection against dust and indefinite immersion in water (up to 2m depth). It is suitable for exterior use, such as pond or pool lighting.
- Mains Connection: Connect the mains supply to the primary input cable using a suitable IP68 rated cable connector or junction box.
- Wiring Colors: Black/Blue (Neutral), Red/Brown (Live), Green & Yellow (Earth).
Wiring and Connections
The LED driver features dual Live and Neutral terminals, allowing for loop-in loop-out wiring between multiple LED drivers.
- Parallel Wiring: All Constant Voltage LED lamps must be wired in parallel.
- Polarity: Correct polarity must be observed for the lamps to operate. Polarity is clearly indicated on both the LED controller and the LED lamps.
- Connections: Ensure all electrical connections are tight with no loose strands.
Safety and Maintenance
- Heat Sources: Keep the LED driver away from direct sources of heat, such as low-voltage lamps.
- Positioning: Do not install the LED driver directly above the luminaire.
- Maintenance: Always isolate from the mains supply before maintenance.
- Guarantee: The warranty is invalid in cases of improper use, tampering, removal of the Q.C. date label, or installation in an improper environment.
Manufacturer information
Aurora Lighting
Practical help
Common problems
Lamps not working
Check that the polarity is correct on both the LED controller and the lamps. Ensure all lamps are wired in parallel.
Loose electrical connections
Ensure all connections are tight and free of loose strands to prevent short circuits or poor contact.
Overheating
Ensure the LED driver is not installed directly above the luminaire and is kept away from heat sources.
Before use
- Isolate the mains supply before starting installation.
- Verify that the total wattage of all connected lamps does not exceed 16W.
- Ensure all LED lamps are wired in parallel.
- Check that the polarity of the 12V DC output matches the lamps.
- Use an IP68 rated connector for mains input if installing the AU-LED16IP model outdoors.
- Ensure all electrical connections are secure.
Images and diagrams
- Parallel Wiring: Illustrates the correct method for connecting multiple lamps to the controller.
- Input Terminals: Shows the loop-in loop-out wiring configuration for mains input.
Model compatibility
- Compatible only with Constant Voltage LED lamps.
- Lamps must be wired in parallel.
- AU-LED16IP is suitable for submerged use; AU-LED16T is a standard variant.
Manual page author
David Miller
Documentation analyst
Organizes user manual content into clear summaries, with attention to model details, product context, and everyday usability.