General / Other Manuals
Installation and Care Guide for Falcon Ridge Kawasaki Teryx 2014-2017 Full Cab with Polycarbonate Windshield
A comprehensive installation and maintenance guide for the Falcon Ridge full cab enclosure for Kawasaki Teryx 2014-2017. Includes step-by-step instructions for installing the rear window, doors, top cap, and windshield, along with cleaning...
Table of contents
Manual images
Jump to the sectionQuick guide from the manual
This document provides installation instructions for the Falcon Ridge Full Cab Enclosure for Kawasaki Teryx 2014-2017. Installation is recommended at temperatures of 70°F (21°C) or warmer to ensure proper adhesion of the Velcro strips. If installing in colder weather, store the adhesive Velcro at room temperature beforehand.
Installation sequence
The cab should be installed in the following order: 1) Rear Window, 2) Doors, 3) Polycarbonate Windshield, 4) Top Cap.
Rear Window installation
Begin by placing 4" adhesive Velcro strips on each side of the Teryx where the side tube meets the top tube. Hang the Rear Window from these strips, centering it properly. Attach double-sided Velcro strips at the top corners, pulling the window tight from side to side. Secure these with 3" adhesive strips. Work down each side, attaching the double-sided Velcro to the center side bar. Finally, attach the bottom straps to the seat frame under the bottom cushion.
Door installation
Place 4" adhesive Velcro strips where the center side bar meets the roll cage. Align the door with the frame and attach the double-sided Velcro strips along the sides. Secure the top rear corner and the bottom edge using the provided adhesive Velcro strips.
Polycarbonate Windshield and Top Cap
Install the windshield according to its specific instructions, but wait until the Top Cap is installed before attaching the bent brace along the top. For the Top Cap, place it over the vehicle with the pointed end facing forward. Secure the front using the grommet straps and the rear using the double-sided Velcro straps wrapped around the roll cage. Ensure the top is centered and all straps are pulled tight through the buckles.
Cleaning and maintenance
Clean the cab with a soft rag or sponge using mild liquid detergent and warm water. Never rub windows with a dry cloth. For storage, roll the cab rather than folding it to prevent damage to the windows. Store at room temperature and avoid extreme heat or cold.
Practical help
Common problems
Adhesive Velcro not sticking properly
Ensure installation is performed at 70°F or warmer. If necessary, store adhesive strips at room temperature before application.
Windows damaged during storage
Never fold the cab for storage. Always roll it into a roll approximately 8 inches in diameter.
Windshield installation issues
Wait until the Top Cap is installed before attaching the bent brace along the top of the windshield.
Before use
- Verify all parts are present according to the parts list (Velcro strips, straps, panels).
- Ensure the installation area is clean, flat, and free of dirt.
- Check that the ambient temperature is at least 70°F.
- Read all instructions thoroughly before beginning.
Specs in practice
- Adhesive Velcro Hook Strips
- Used to secure the enclosure panels to the vehicle frame.
- Double-sided Velcro
- Used to attach the enclosure fabric to the roll cage bars.
Images and diagrams
- The manual includes diagrams showing the correct way to lace the webbing through the buckles.
- Illustrations demonstrate the placement of adhesive Velcro strips on the roll cage tubes.
- Photos show the correct orientation of the Top Cap and the attachment of straps.
Model compatibility
- Designed specifically for Kawasaki Teryx 2014-2017.
- The rear window is designed to leave most of the center side bar exposed to allow door magnets to function correctly.
Manual page author
David Miller
Documentation analyst
Organizes user manual content into clear summaries, with attention to model details, product context, and everyday usability.