Installation and Care Guide for Falcon Ridge Soft Rear Window for Arctic Cat / Textron Prowler Pro

Quick installation and maintenance guide for the Falcon Ridge Soft Rear Window (AC-PRO-RW01). Includes step-by-step mounting instructions, cleaning tips, and storage recommendations.

Table of contents

Manual images

Jump to the section

Placement of the 53-inch adhesive Velcro strip on the upper frame.

Page 2

Placement of the 53-inch adhesive Velcro strip on the lower frame.

Page 2

Placement of the 20-inch adhesive strip on the side frame.

Page 3

Quick guide from the manual

This document provides instructions for installing the Falcon Ridge Soft Rear Window (model AC-PRO-RW01) on Arctic Cat / Textron Prowler Pro vehicles. The installation is best performed in temperatures of 70 degrees F (21 degrees C) or warmer to ensure proper adhesive Velcro performance. If working in colder conditions, store the adhesive strips at room temperature before installation.

Installation

Preparation: Check all parts against the included list. If any items are missing or damaged, contact customer service at 606-845-7439.
Cleaning: Thoroughly clean the roll cage and plastic surrounding the doors using rubbing alcohol. This is critical for the adhesive strips to bond correctly.
Applying Velcro: Install the two 53-inch adhesive Velcro strips on the frame above and below the rear window area. Ensure these strips are centered.
Side Strips: Install the 20-inch adhesive strips down each side of the rear window frame.
Final Attachment: Attach the rear window to the frame, ensuring it is centered correctly.

Cleaning and Storage Recommendations

Proper care will extend the life of your cab enclosure:

Cleaning: Clean with a soft rag or sponge using a mild liquid detergent and warm water. Never use a dry cloth or rag, as this can scratch the vinyl windows. Allow the cab to dry completely before rolling it up.
Storage: Always roll the cab for storage rather than folding it, as folding can cause permanent damage to the windows. Roll the cab to a diameter of approximately 8 inches and store at room temperature. Avoid exposure to extreme heat or cold.

Practical help

Common problems

Velcro strips not adhering properly

Ensure the roll cage and plastic surfaces are thoroughly cleaned with rubbing alcohol before application. Perform installation in temperatures of 70 degrees F or warmer.

Vinyl windows scratched

Never rub the windows with a dry cloth or rag. Use a soft rag or sponge with mild liquid detergent and warm water.

Windows damaged during storage

Do not fold the cab. Always roll it up to a diameter of approximately 8 inches.

Before use

Verify all parts are present (Rear Window, 2x 53-inch Velcro strips, 2x 20-inch Velcro strips).
Ensure ambient temperature is at least 70 degrees F.
Clean mounting surfaces with rubbing alcohol.
Ensure the cab is completely dry before rolling for storage.

Specs in practice

Operating Temperature: Best installed at 70 degrees F or warmer for optimal adhesive performance.
Storage Method: Must be rolled (approx. 8-inch diameter) to prevent damage to vinyl windows.

Images and diagrams

The manual includes photos showing the placement of the 53-inch Velcro strips on the frame above and below the rear window.
A photo illustrates the placement of the 20-inch adhesive strips along the sides of the rear window frame.

Model compatibility

Designed specifically for Arctic Cat / Textron Prowler Pro.

Show more Show less

Manual page author

Emily Carter

User documentation editor

Prepares concise manual descriptions and highlights the most useful setup, operation, and maintenance information for readers.