Plumbing / Showers & Tubs
Installation and User Manual for Hansgrohe Vernis Blend and Vernis Shape Showerpipe
Quick guide for installing and operating the Hansgrohe Vernis Blend and Vernis Shape Showerpipe series. Includes assembly steps, technical specifications, and maintenance tips.
Quick answers from the manual
Quick answer
- This manual provides installation and operating instructions for the Hansgrohe Vernis Blend and Vernis Shape Showerpipe series. It covers safety, mounting, maintenance, and technical specifications. p. 2, 3
Key actions
- Install the mesh washer p. 2, 3
- Tilt shower head to drain p. 2, 3
First start
- Flush pipes before installation p. 2, 3
Problems and fixes
Water not draining from overhead shower
Tilt the shower head slightly after use.
p. 2, 3Technical specifications
| Parameter | Value | Meaning | Pages |
|---|---|---|---|
| Max Operating Pressure | 1 MPa | Maximum allowed pressure | p. 2, 3 |
Where to find it in the PDF
- Installation p. 18
- Technical Data p. 2, 3
Table of contents
Manual images
Click an image to enlargeQuick guide from the manual
This document provides installation and usage instructions for the Hansgrohe Vernis Blend and Vernis Shape Showerpipe series. The system is designed for bathing and body hygiene. Important: The shower head should be tilted slightly after use to ensure it drains properly. The product must not be used as a grab handle.
Installation
Installation must be performed by qualified personnel. Ensure the mounting surface is flat and stable. The provided mesh washer must be installed to protect the shower from dirt in the water supply, as damage caused by dirt is not covered by the warranty.
- Check the product for transport damage before installation.
- Flush pipes according to applicable standards before connecting the fixture.
- The installation dimensions are ideal for a person approximately 1800 mm tall but can be adjusted if necessary.
- Use gloves during installation to prevent injury.
- Do not use silicone containing acetic acid.
Operation
The shower system is operated via the connected sanitary fitting or shut-off valve. To empty the overhead shower after use, hold it in a slightly inclined position.
Maintenance and Cleaning
To clean the shower, simply rub the spray nozzles to remove lime scale (QuickClean technology). For deeper cleaning, follow the manufacturer's recommendations on the official website. The mesh washer/filter should be checked and cleaned periodically to maintain water flow.
Technical Data
- Operating pressure: max. 1 MPa
- Recommended operating pressure: 0.1 - 0.4 MPa
- Hot water temperature: max. 60°C
- Thermal disinfection: 70°C / 4 min
- Usage: Designed exclusively for drinking water.
Manufacturer information
Hansgrohe SE
Practical help
Common problems
Overhead shower does not drain
Tilt the shower head slightly after use to allow water to drain.
Reduced water flow
Check and clean the mesh washer/filter in the shower connection.
Before use
- Inspect product for transport damage
- Ensure water supply pressure is equal
- Install the included mesh washer
- Ensure mounting surface is flat and stable
- Flush pipes before final connection
Specs in practice
- Operating pressure
- Maximum pressure the system can withstand (1 MPa = 10 bar = 147 PSI)
- Recommended pressure
- Optimal pressure range for best performance (0.1 - 0.4 MPa)
- Hot water temperature
- Maximum safe temperature for the system (60°C)
Images and diagrams
- Flow diagram shows water output performance for hand and overhead showers
- Dimensions diagram provides necessary spacing for installation
Model compatibility
- Designed for drinking water systems
- Not intended for use as a support handle
Manual page author
David Miller
Documentation analyst
Organizes user manual content into clear summaries, with attention to model details, product context, and everyday usability.