Hinkley 15074SS Dot LED Button Light Installation Instructions

Quick guide from the manual

This document provides installation instructions for the Hinkley Dot Family LED button lights (Model 15074SS/15084). These fixtures are designed for 12V power systems. Safety Warning: Always turn off the power supply before beginning installation. If new wiring is required, consult a qualified electrician.

Mounting options

The fixture can be installed using one of three methods:

• Option 1 (Surface Mount): Requires a 1-inch drill. Suitable for walls with a depth of 1/4 inch or greater.
• Option 2 (Cast in Concrete): Requires cutting 1-inch SCH40 plumbing or drainage PVC pipe to a length of at least 4.5 inches.
• Option 3 (Sleeve Mount): Use the provided extruded PVC sleeve to cast or bury the fixture.

Wiring instructions

1. Remove excess wire and use an appropriate tool to strip the outer jacket of the cable.
2. Expose the positive (black) and negative (white) lead wires.
3. Strip the two wire leads from the luminaire.
4. Connect the luminaire leads to the main supply wire using the provided silicone-filled wire nut.
5. Note: Silicone-filled wire nuts are for one-time use only.
6. Wire nut capacity: Supports 2 pieces of 18 AWG or 2 pieces of 12 AWG wire.
7. Place the fixture housing and front cover into the mounting sleeve, PVC sleeve, or wall.

Important notes

Multiple fixtures can be wired to a single transformer or power source. Please refer to the specifications of your power source or transformer to ensure the total load does not exceed the maximum capacity.